IEC 61237-1-1994 PDF

IEC 61237-1-1994 PDF

Broadcast Video Tape Recorders - Methods of Measurement - Part 1: Mechanical Measurements

$50.44 $100.88 -50%
Product Code: IEC 61237-1
Stock In Stock
Edition: 1.0
Published: 06/1994
Number of Pages: 36
File Size: 1 file, 1 Byte

Available Options

Product Description

Broadcast Video Tape Recorders - Methods of Measurement - Part 1: Mechanical Measurements

Scope: This part of IEC 1237 describes the mechanical measurement methods on video tape recorders relating to the compatibility parameters for recording and measuring methods of the recorded tape. The allowable tolerances for the rated values for acceptable performance are not given in this standard, but may be derived from the specifications for the related system i.e. appropriate publications, manufacturers' specifications, etc. The necessary reference and calibration tapes are either mentioned in the specific IEC publication of the equipment under test or included in IEC 1105. This standard deals with special mechanical measurement techniques for broadcast VTRs. It does not, however, cover the special mechanical measurements of the earlier transverse track video recorder standard (IEC 347). For those measurements see IEC 1055. The methods are applicable to acceptance tests, performance comparison and, as far as possible, for routine checks.

Contents:

  • FOREWORD
  • 1 Scope
  • 3 General
  • 5 Measuring equipment
  • 5.1 Mechanical measurements
  • 5.2 Optical measurements
  • 6 Recorder measurements
  • 6.1 Diameter of drum
  • 6.2 Projection of video head pole tips
  • 6.2.1 Mechanical measurement
  • 6.2.2 Optical measurement
  • 6.3 Gap width of video heads
  • 6.4 Coplanarity error of video heads
  • 7 Measurements on recorded tape
  • 7.1 Tape speed and pitch of the video tracks
  • 7.1.1 Tape speed v (first method)
  • 7.1.2 Track pitch J (first method)
  • 7.1.3 Tape speed and pitch of the video tracks (second method)
  • 7.2 Position of the video reference point (VRP)
  • 7.2.1 Measurement of the VRP position (first method)
  • 7.2.2 Tracking and drum phase error (second method)
  • 7.3 Location of records on sound and time code tracks
  • 7.3.1 Track location to the reference tape edge
  • 7.3.2 Longitudinal location of records
  • 7.4 Video track geometry
  • 7.4.1 Video track width I
  • 7.4.2 Cross-tape measuring technique (first method)
  • 7.4.3 Dynamic track measurement (second method)

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61237-1-1994 PDF

IEC 61237-1-1994 PDF

$50.44 $100.88