IEC 61280-2-12-2014 PDF

IEC 61280-2-12-2014 PDF

Fibre optic communication subsystem test procedures-Part 2-12: Digital systems-Measuring eye diagrams and Q-factor using a software triggering technique for transmission signal quality assessment

$72.51 $145.02 -50%
Product Code: IEC 61280-2-12
Stock In Stock
Edition: 1.0
Published: 05/2014
Number of Pages: 44
File Size: 1 file, 488 Bytes

Available Options

Product Description

Fibre optic communication subsystem test procedures – Part 2-12: Digital systems – Measuring eye diagrams and Q-factor using a software triggering technique for transmission signal quality assessment

Introduction: Signal quality monitoring is important for operation and maintenance of optical transport networks (OTN). From the network operator’s point of view, monitoring techniques are required to establish connections, protection, restoration, and/or service level agreements. In order to establish these functions, the monitoring techniques used should satisfy some general requirements: in-service (non-intrusive) measurement signal deterioration detection (both SNR degradation and waveform distortion) fault isolation (localize impaired sections or nodes) transparency and scalability (irrespective of the signal bit rate and signal formats) simplicity (small size and low cost). There are several approaches, both analogue and digital techniques, which make it possible to detect various impairments: bit error rate (BER) estimation [1,2]1 error block detection optical power measurement optical SNR evaluation with spectrum measurement [3,4] pilot tone detection [5,6] Q-factor monitoring [7] pseudo BER estimation using two decision circuits [8,9] histogram evaluation with synchronous eye diagram measurement [10]. A fundamental performance monitoring parameter of any digital transmission system is its end-to-end BER. However, the BER can be correctly evaluated only with out of service BER measurements, using a known test bit pattern in place of the real signal. On the other hand, in-service measurement can only provide rough estimates through the measurement of digital parameters (e.g., BER es

Scope: This part of IEC 61280 defines the procedure for measuring eye diagrams and Q-factor of optical transmission (RZ and NRZ) signals using software triggering technique as shown in 4.1 [14].

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61280-2-12-2014 PDF

IEC 61280-2-12-2014 PDF

$72.51 $145.02