IEC 61280-2-13-2024 PDF

IEC 61280-2-13-2024 PDF

Fibre optic communication subsystem test procedures − Part 2-13: Digital systems − Measurement of error vector magnitude

$100.88 $201.76 -50%
Product Code: IEC 61280-2-13
Stock In Stock
Edition: 1.0
Published: 07/2024
Number of Pages: 54
File Size: 1 file, 2 Bytes

Available Options

Product Description

Fibre optic communication subsystem test procedures − Part 2-13: Digital systems − Measurement of error vector magnitude

Introduction: The error vector magnitude (EVM) is a single, real-valued parameter that characterizes the signal quality of n-state amplitude phase shift keyed (n-APSK) signals, which are also known as vector modulated signals. Similar to the Q-factor used for intensity-modulated directly-detected optical signals, it measures the average deviations of the transmitted signal states from their ideal values. These deviations can be caused by noise and by linear and nonlinear waveform distortions. The EVM is therefore a useful quantity to characterize the quality of transmitted source signals at the input of a transmission system or the quality of received signals at the output of a transmission system [1]1. Despite the fact that the EVM is often reported by commercial optical modulation analysers, there are only a few standards that define a procedure for calculating the EVM of optical signals. ITU-T Recommendation G.698.2 [2], for example, specifies a maximal EVM value for polarization-multiplexed 100 Gbit/s QPSK signals generated by an optical transmitter at the input of a DWDM transmission system. These recommendations provide detailed instructions for numerical signal processing steps that are to be performed on the received signal before the EVM is calculated. The steps include removal of undesired frequency and phase offsets, spectral filtering, DC offset removal, and even the addition of artificial noise to the signal. Similarly, OIF Implementation Agreement OIF-400ZR-01.0 [3] describes

Scope: This part of the IEC 61280-2 series defines a procedure for calculating the root-mean-square error vector magnitude of optical n-APSK signals from a set of measured symbols. It specifically defines the normalization of the reference states and a procedure for optimal scaling of the measured symbol states. The procedure described in this document applies to single-polarized optical signals as well as to conventional polarization-multiplexed signals with independently modulated polarization tributaries. In general, it is not advisable to apply these procedures without modification to signals, in which optical amplitude, phase, and polarization state are simultaneously modulated to encode the information data. This document does not specify any signal processing steps for extracting the symbols from the received optical signals, because these steps depend on the optical receiver and can vary with the type of the transmitted n-APSK signal. These and optional additional signal processing steps are defined in application-specific documents.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61280-2-13-2024 PDF

IEC 61280-2-13-2024 PDF

$100.88 $201.76