Fibre optic communication subsystem test procedures – Part 4-3: Installed passive optical networks – Attenuation and optical return loss measurements
Introduction: IEC has developed a large set of standards for measurement of fibre optic cable plants. These standards are applicable to passive optical networks (PONs) if specifics of these networks are known and understood. This document provides dedicated procedures for attenuation measurements in PONs as well as additional information. For the purpose of this document, a PON is a point-to-multipoint network that includes optical line terminals (OLTs), optical network terminals (ONTs), and an optical fibre infrastructure that is entirely passive and is represented by a single-rooted point-to-multipoint tree of optical fibres with splitters, combiners, filters, and other passive components. PONs are commonly used in fibre-to-the-home (FTTH) and fibre-to-the-building (FTTB) optical access networks (OAN). In addition, the measurement principles described in this document may also apply to PONs used in other applications, like passive optical local area networks (PO-LANs).
Scope: This part of IEC 61280 describes the measurement of attenuation, optical return loss and optical power in installed passive optical networks (PONs) using single-mode fibre. This document specifies two methods for measuring the attenuation before activation of the PON: method A: one-cord method using a light source and a power meter (LSPM); method B: optical time-domain reflectometer (OTDR) method in upstream direction only, with reduction of uncertainties due to the variation of backscatter coefficient. In addition, method C, which is described in informative Annex C, provides an estimate of the attenuation after partial activation of the PON by using a U band filtered optical time-domain reflectometer (FOTDR) in an upstream direction.
Contents:
- FOREWORD
- INTRODUCTION
- Scope