IEC 61291-6-1-2008 PDF

IEC 61291-6-1-2008 PDF

Optical amplifiers-Part 6-1: Interfaces-Command set

$100.88 $201.76 -50%
Product Code: IEC 61291-6-1
Stock In Stock
Edition: 1.0
Published: 08/2008
Number of Pages: 54
File Size: 1 file, 1 Byte

Available Options

Product Description

Optical amplifiers – Part 6-1: Interfaces – Command set

Introduction: Optical amplifiers are being developed and commercially deployed with an increasing degree of sophistication and functionality. Often, information is sent to the optical amplifier, or requested from it, in order to determine signal conditions, operating parameters, and to adjust the operational aspects of the optical amplifier. Currently, no International Standard exists in this area, yet the need for a common set of command statements to/from optical amplifiers has emerged. This part of IEC 61291 proposes a set of command strings useful in controlling optical amplifiers. It is based on an existing set of commands widely used across the industry today. The standardization of this command set will result in broader market use of advanced designs of optical amplifiers, typically controlled by microprocessors. These advanced amplifier designs are needed for next generation optical networks, requiring adaptive provisioning of optical paths and intelligent configuration/reconfiguration for provision of telecommunications services in a dynamic environment. This standard addresses the structure and content of the command set to control optical amplifiers. It does not cover the physical or hardware interface which is assumed to exist for communication of this command set to the optical amplifier. The specification of a physical interface will be the subject of a separate standard yet to be developed. With the rapidly evolving technology, it is envisioned that this standard will be am

Scope: This part of IEC 61291 describes the optical amplifier command set (OACS) for use in communicating with and controlling intelligent optical amplifiers. These amplifiers can receive and possibly respond to such commands by using resident firmware or may be optical amplifiers controlled by a microprocessor. This standard addresses the structure and content of the command set to control optical amplifiers. It does not cover the physical or hardware interface, which is assumed to exist for communication of this command set to the optical amplifier. The specification of a physical interface will be the subject of a separate Part to be developed in the IEC 61291-6 series. The command set described in this standard is intended to enable a user or host to retrieve the amplifier module’s status and/or adjust its settings. This standard lists all of the commands currently defined and supported within the OACS framework. The commands described cover a wide range of applications, and not all commands will be applicable to every amplifier. To determine the supported commands on an OACS compliant amplifier, please refer to the product specification supplied by the manufacturer. All OACS compliant amplifiers support the full set of “universal” OACS commands. Other commands, usually specific to a design or implementation, may support some or all of the “optional” commands.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61291-6-1-2008 PDF

IEC 61291-6-1-2008 PDF

$100.88 $201.76