IEC 61315-2019 PDF

IEC 61315-2019 PDF

Calibration of fibre-optic power meters

$186.00 $371.99 -50%
Product Code: IEC 61315
Stock In Stock
Edition: 3.0
Published: 03/2019
Number of Pages: 92
File Size: 1 file, 2 Bytes

Available Options

Product Description

Calibration of fibre-optic power meters

Introduction: Fibre-optic power meters are designed to measure optical power from fibre-optic sources as accurately as possible. This capability depends largely on the quality of the calibration process. In contrast to other types of measuring equipment, the measurement results of fibre-optic power meters usually depend on many conditions of measurement. The conditions of measurement during the calibration process are called calibration conditions. Their precise description is therefore an integral part of the calibration. This document defines all of the steps involved in the calibration process: establishing the calibration conditions, carrying out the calibration, calculating the uncertainty, and reporting the uncertainty, the calibration conditions and the traceability. The absolute power calibration describes how to determine the ratio between the value of the input power and the power meter's result. This ratio is called correction factor. The measurement uncertainty of the correction factor is combined following Annex A from uncertainty contributions from the reference meter, the test meter, the setup and the procedure. The calculations go through detailed characterizations of individual uncertainties. It is important to know that a) some uncertainties are type B estimations, experience-based, b) a detailed uncertainty analysis is usually only done once for each power meter type under test, and all subsequent calibrations are usually based on this one-time analysis, using the approp

Scope: This document is applicable to instruments measuring radiant power emitted from sources that are typical for the fibre-optic communications industry. These sources include laser diodes, light emitting diodes (LEDs) and fibre-type sources. Both divergent and collimated radiations are covered. This document defines the calibration of power meters to be performed by calibration laboratories or by power meter manufacturers.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61315-2019 PDF

IEC 61315-2019 PDF

$186.00 $371.99