IEC 61334-3-21-1996 PDF

IEC 61334-3-21-1996 PDF

Distribution Automation Using Distribution Line Carrier Systems - Part 3: Mains Signalling Requirements - Section 21: MV Phase-to-Phase Isolated Capacitive Coupling Device

$72.51 $145.02 -50%
Product Code: IEC 61334-3-21
Stock In Stock
Edition: 1.0
Published: 03/1996
Number of Pages: 38
File Size: 1 file, 1 Byte

Available Options

Product Description

Distribution Automation Using Distribution Line Carrier Systems - Part 3: Mains Signalling Requirements - Section 21: MV Phase-to-Phase Isolated Capacitive Coupling Device

Introduction: The already standardized capacitive coupling devices for power-line carrier systems (i.e. phase-to-earth and phase-to-phase) could be applied on DLC systems. In this case recommendations of IEC 481 are fully applicable. However, the above-mentioned coupling devices are not fully suitable for an extensive application of DLC on MV networks for the following reasons: from a technical point of view, earthing the primary winding of the coupling transformer may cause unbalancing in the zero sequencing current, with negative effects on the directional overcurrent relay protections; from an economical point of view, the coupling device should have a price as low as possible. These considerations lead to the standardization of another coupling device such as the MV phase-to-phase isolated capacitive coupling device, where "isolated" means: no connection of the primary section of the coupling device to the earth. Figure 1 shows a solution. Other solutions may become available. As other coupling devices are standardized, new sections to IEC 1334-3 will be added.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 3.1 MV phase-to-phase capacitive coupling method
  • 3.2 Coupling device
  • 3.3 Terms concerning coupling devices
  • 4.1 Standard conditions
  • 4.2 Ambient temperature
  • 4.3 Power frequency
  • 4.4 Operating voltages
  • 5 General requirements
  • 5.1 Safety and protection requirements
  • 5.2 Insulation requirements
  • 5.3 Carrier-frequency requirements
  • 5.4 Rating plate
  • 5.5 Tests
  • 2 Main components of a MV phase-to-phase isolated coupling device
  • 4 Common mode impulse voltage test
  • 6 Measurement of composite loss
  • 7 Measurement of return loss
  • 8 Measurement of the nominal coupling-side impedance
  • 9 Measurement of the nominal equipment-side impedance
  • 10 Measurement of the 3 dB bandwidth

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61334-3-21-1996 PDF

IEC 61334-3-21-1996 PDF

$72.51 $145.02