Waveguide type dielectric resonators - Part 1-5: General information and test conditions - Measurement method of conductivity at interface between conductor layer and dielectric substrate at microwave frequency
Introduction: IEC 61338 consists of the following parts, under the general title Waveguide type dielectric resonators: Part 1: Generic specification Part 1-3: General information and test conditions − Measurement method of complex relative permittivity for dielectric resonator materials at microwave frequency Part 1-4: General information and test conditions − Measurement method of complex relative permittivity for dielectric resonator materials at millimeter-wave frequency Part 2: Guidelines for oscillator and filter applications Part 4: Sectional specification Part 4-1: Blank detail specification The International Electrotechnical Commission (IEC) draws attention to the fact that it is claimed that compliance with this document may involve the use of a patent concerning: The use of a TE01δ mode dielectric rod resonator for the interface resistance and the interface conductivity measurement, given in Clause 4; The use of a substrate/conductor/substrate layer structure, where a conductor is formed between two dielectric substrates, for the interface resistance and interface conductivity measurement, given in Clause 5. IEC takes no position concerning the evidence, validity and scope of this patent right. The holder of this patent right has assured the IEC that he/she is willing to negotiate licences under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with IEC. Info
Scope: Microwave circuits are popularly formed on multi-layered organic or non-organic substrates. In the microwave circuits, the attenuation of planar transmission lines such as striplines, microstrip lines, and coplanar lines are determined by their conductor loss, dielectric loss and radiation loss. Among them, the conductor loss is a major factor in the attenuation of the planar transmission lines. A new measurement method is standardized in this document to evaluate the conductivity of transmission line on or in the substrates such as the organic, ceramic and LTCC (low temperature co-fired ceramics) substrates. This standard describes a measurement method for resistance and effective conductivity at the interface between conductor layer and dielectric substrate, which are called interface resistance and interface conductivity. This measurement method has the following characteristics: the interface resistance Ri is obtained by measuring the resonant frequency f0 and unloaded quality factor Qu of a TE01δ mode dielectric rod resonator shown in Figure 2; the interface conductivity σi and the relative interface conductivity σri = σi / σ0 are calculated from the measured Ri value, where σ0 = 5,8 × 107 S/m is the conductivity of standard copper; the measurement uncertainty of σri (Δσri) is less than 5 %.
Contents:
- FOREWORD
- INTRODUCTION
- Scope