Railway applications - Rolling stock equipment - Shock and vibration tests
Introduction: This document covers the requirements for random vibration and shock testing items of pneumatic, electrical and electronic equipment or components (hereinafter only referred to as equipment) to be fitted on to railway vehicles. Random vibration and shock is the only method to be used for equipment or component approval. The tests contained within this document are specifically aimed at demonstrating the ability of the equipment under test to withstand the type of environmental vibration conditions normally expected for railway vehicles. In order to achieve the best representation possible, the values quoted in this document have been derived from actual service measurements submitted by various contributing bodies from around the world. This document is not intended to cover self-induced vibrations as these will be specific to particular applications. Engineering judgement and experience are recommended in the execution and interpretation of this document. This document is suitable for design and validation purposes; however, it does not exclude the use of other development tools (such as sine sweep), which can be used to ensure a predetermined degree of mechanical and operational confidence. The test levels to be applied to the equipment under test are dictated only by its location on the train (i.e. axle, bogie or body-mounted). It should be noted that these tests can be performed on prototypes in order to gain design information about the product performance under random v
Scope: This document specifies the requirements for testing items of equipment intended for use on railway vehicles which are subsequently subjected to vibrations and shock owing to the nature of railway operational environment. To gain assurance that the quality of the equipment is acceptable, it is exposed to tests of reasonable duration that simulate the service conditions seen throughout its expected life. Simulated long-life testing can be achieved in a number of ways each having their associated advantages and disadvantages, the following being the most common: a) amplification: where the amplitudes are increased and the time base decreased; b) time compression: where the amplitude history is retained and the time base is decreased (increase of the frequency); c) decimation: where time slices of the historical data are removed when the amplitudes are below a specified threshold value. The amplification method as stated in item a) above, is used in this document and together with the publications referred to in Clause 2; it defines the default test procedure to be followed when vibration testing items for use on railway vehicles. Whilst this document is primarily concerned with railway vehicles on fixed rail systems, its wider use is not precluded. For systems operating on pneumatic tyres, or other transportation systems such as trolleybuses, where the level of shock and vibration clearly differ from those obtained on fixed rail systems, specific test levels can be considered. In that case, the frequency spectra and the shock duration and amplitude are computed in compliance with the guidelines in Annex A. Annex F provides the functional random vibration load that can be considered by the user for urban vehicles operating on pneumatic tyres. This document applies to single axis testing. However, multi-axis testing is possible. The anchoring bolts at the fixing point(s) of the equipment are not evaluated in this document. This document is intended to evaluate equipment which is attached to the main structure of the vehicle (and components mounted thereon). It is not intended to test equipment which forms part of the main structure. Main structure in the sense of th
Contents:
- FOREWORD
- INTRODUCTION
- Scope