Low-voltage switchgear and controlgear assemblies – Part 3: Distribution boards intended to be operated by ordinary persons (DBO) (Commented Version)
Scope: This part of IEC 61439 defines the specific requirements for distribution boards intended to be operated by ordinary persons (abbreviated DBO throughout this document, see 3.1.101) as follows: assemblies intended to be operated by ordinary persons (e.g. switching operations and replacing fuse-links), e.g. in domestic (household) applications; assemblies containing outgoing circuits with protective devices intended to be operated by ordinary persons, complying e.g. with IEC 60898-1, the IEC 61008 series, the IEC 61009 series, IEC 62606, IEC 62423 and IEC 60269-3; assemblies for applications where the rated nominal 1 voltage to earth does not exceed 300 V AC (see Table G.1 of IEC 61439-1:2020); NOTE The voltage limits for DC applications are under consideration. assemblies with a rated current (Inc) of the outgoing circuits not exceeding 125 A and a rated current (InA) not exceeding 250 A; assemblies intended for use in connection with the generation, transmission, distribution and conversion of electrical energy, and for the control of equipment consuming electrical energy and for associated data processing; 2 enclosed, stationary assemblies; assemblies for indoor or outdoor use. DBOs may also include control and/or signaling devices associated with the distribution of electrical energy. DBOs may be assembled outside the factory of the original manufacturer. 3 DBOs can contain protection devices, control devices, signalling devices alone or a combination of devices e.g. circuit-breakers, load shedding relay, energy management, communication devices, lighting control. 4 This document does not apply to an empty enclosure nor to individual devices and self-contained components, such as circuit-breakers, fuse-switches, electronic equipment, etc. which comply with the relevant product standards, it describes the integration of devices, or self-contained components, or both, into a DBO or into an empty enclosure forming a DBO. This document applies to DBOs designed, manufactured, and verified on a one-off basis or fully standardized and manufactured in quantity. This document does not apply to the specific types of assemblies covered by other parts of the IEC 61439 ser
Contents:
- FOREWORD
- Scope
- 10 Design verification
- 11 Routine verification