Composite hollow insulators – Pressurized and unpressurized insulators for use in electrical equipment with AC rated voltage greater than 1 000 V AC and D.C. voltage greater than 1500V – Definitions, test methods, acceptance criteria and design recommendations
Introduction: Composite hollow insulators consist of an insulating tube bearing the mechanical load protected by an elastomeric housing, the loads being transmitted to the tube by metal fittings. Despite these common features, the materials used and the construction details employed by different manufacturers may vary. Some tests have been grouped together as "Design tests" to be performed only once for insulators of the same design and material. The design tests are performed in order to eliminate designs and materials not suitable for high-voltage applications. The relevant design tests defined in IEC 62217 are applied for composite hollow insulators; additional specific mechanical tests are given in this document. The influence of time on the electrical and mechanical properties of the complete composite hollow insulator and its components (tube material, housing material, interfaces, etc.) has been considered in specifying the design tests in order to ensure a satisfactory lifetime under normal service conditions. These conditions may also depend on the equipment inside or outside the composite hollow insulators; however, this matter has not been covered in this document. It is possible for test methods not specified in this document to be considered for specific combinations of materials and specific applications, and are a matter of agreement between manufacturers and users. In this document, the term "user" in general means the equipment manufacturer using composite hollow insulator
Scope: This document, which is an International Standard, applies to composite hollow insulators consisting of a load-bearing insulating tube made of resin impregnated fibres, a housing (outside the insulating tube) made of elastomeric material (for example silicone or ethylene- propylene) and metal fixing devices at the ends of the insulating tube (see Figure D.1 and Figure D.2 for examples). Composite hollow insulators as defined in this document are intended for general use (unpressurized) or for use with a permanent gas pressure (pressurized). They are intended for use in both outdoor and indoor electrical equipment operating on alternating current with a rated voltage greater than 1 000 V AC and a frequency not greater than 100 Hz or for use in direct current equipment with a rated voltage greater than 1 500 V DC. The object of this document is: to define the terms used; to specify test methods; to specify acceptance criteria. Hollow insulators are integrated into electrical equipment which is electrically type tested as required by the applicable equipment standard. So, it is not the object of this document to specify dielectric type tests because the withstand voltages and flashover behaviour are not characteristics of the hollow insulator itself but of the apparatus of which it ultimately forms a part. All the tests in this document, apart from the thermal-mechanical test, are performed at normal ambient temperature. This document does not specify tests that might be characteristic of the equipment of which the hollow insulator ultimately forms a part. Composite hollow insulators are intended for use in electrical equipment, such as, but not limited to: HV circuit-breakers, switch-disconnectors, disconnectors, station posts, disconnecting circuit breakers, earthing switches, instrument- and power transformers, bushings, housing for surge arresters, cable terminations. Additional testing defined by the relevant IEC equipment standard may be required. IEC 61462:2023 © IEC 2023 – 9 –
Contents:
- FOREWORD
- INTRODUCTION
- Scope