IEC 61481-2-2014 PDF

IEC 61481-2-2014 PDF

Live working-Phase comparators-Part 2: Resistive type to be used for voltages from 1 kV to 36 kV a.c.

$239.59 $479.18 -50%
Product Code: IEC 61481-2
Stock In Stock
Edition: 1.0
Published: 10/2014
Number of Pages: 164
File Size: 1 file, 1 Byte

Available Options

Product Description

Live working – Phase comparators – Part 2: Resistive type to be used for voltages from 1 kV to 36 kV a.c.

Introduction: This International Standard has been prepared in accordance with the requirements of IEC 61477. Taking into consideration the functioning principle of portable phase comparators of resistive type available on the market, the associated maximum a.c. nominal voltage is 36 kV. The rationale for this maximum nominal voltage is: design of the phase comparator for operation by one person (see 4.4.2) – ergonomic consideration. With higher nominal voltages, the distance between phases of the installation increases and the positioning of the two poles of the phase comparator by one person becomes a limitation; correct performance of each component (including the connecting lead) under normal working conditions – performance consideration; possible contact of the connecting lead between the two poles of the phase comparator with a part of the installation at a phase or earth potential under normal working conditions. The product covered by this standard may have an impact on the environment during some or all stages of its life cycle. These impacts can range from slight to significant, be short-term or long-term, and occur at the global, regional or local level. In terms of environmental improvement, this standard includes neither requirements nor test provisions for the manufacturers of the product nor recommendations to the users of the product. However, all parties intervening in its design, manufacture, packaging, distribution, use, maintenance, repair, reuse, recovery and disposal

Scope: This part of IEC 61481 is applicable to portable phase comparators of resistive type to be used on electrical systems for voltages from 1 kV a.c. to 36 kV a.c. and frequencies of 50 Hz and/or 60 Hz. This standard is applicable to phase comparators of resistive type used in contact with the bare conductive parts to be compared: as a complete device including its insulating element or as a separate device, adaptable to an insulating stick which, as a separate tool, is not covered by this standard. NOTE Some parts such as the contact electrode or the insulating element of a phase comparator as a complete device may be dismantled. Some restrictions on their use are applicable in the case of factory-assembled switchgear and on overhead systems of electrified railways (see Annex A). A device that is designed to provide other functions than phase comparison is a different device and is not covered by this standard. For example a device designed to be also used as a voltage detector is not covered by this standard (see Annex A). Products designed and manufactured according to this standard contribute to the safety of the users provided they are used by persons trained for the work, in accordance with the hot stick working method and the instructions for use. Except when otherwise specified, all the voltages defined in this standard refer to phase-to- phase voltages of three-phase systems. In other systems, the applicable phase-to-phase or phase-to-earth (ground) voltages should be used to determine the operating voltage.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61481-2-2014 PDF

IEC 61481-2-2014 PDF

$239.59 $479.18