IEC 61566-1997 PDF

IEC 61566-1997 PDF

Measurement of Exposure to Radiofrequency Electromagnetic Fields - Field Strength in the Frequency Range 100 kHz to 1 GHz

$132.41 $264.81 -50%
Product Code: IEC 61566
Stock In Stock
Edition: 1.0
Published: 06/1997
Number of Pages: 62
File Size: 1 file, 198 Bytes

Available Options

Product Description

Measurement of Exposure to Radiofrequency Electromagnetic Fields - Field Strength in the Frequency Range 100 kHz to 1 GHz

Introduction: Recent publications by national and international authorities responsible for developing safety limits on exposure to radiofrequency electromagnetic fields show a consensus towards making specific energy absorption rate (SAR) and induced current in the human body the basic limits. Since instruments are not yet available to measure SAR directly, and because SAR and circulating current will vary from person to person, depending on their height and weight, recent standards specify derived secondary levels for field strength, and/or equivalent plane-wave power flux density, for worst case conditions of electrical coupling and body size and weight. However, in some situations, where a wide spatial variation of field strength is present, for example, when climbing an antenna tower or mast, it may be more appropriate to measure the contact current through the hands or feet. Measurements of contact current are not covered by this International Standard.

Scope: This International Standard applies to measurements of electromagnetic fields from operational transmitting equipment to ensure that the transmissions do not constitute a potential hazard to workers or to the general public. The purpose of this standard is to promote a common understanding of technical requirements and precautions necessary for the accurate measurement of electromagnetic fields carried out in conjunction with relevant national exposure regulations. This standard covers transmissions in the frequency range 100 kHz to 1 GHz. NOTE – Possible extension of this frequency range up to 2 GHz or 3 GHz will be investigated. This International Standard does not specify limiting values for exposure as these are usually given in exposure standards issued by responsible health authorities. This standard is, therefore, intended to be used in conjunction with the relevant national standards or regulations applicable in the country concerned. In the absence of any national rules restricting exposure to radiofrequency electromagnetic fields, the recommendations of the International Non- Ionizing Radiation Committee (INIRC) may be followed. The 1988 INIRC recommendations on exposure limits are summarized in annex A.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61566-1997 PDF

IEC 61566-1997 PDF

$132.41 $264.81