IEC 61643-41-2025 PDF

IEC 61643-41-2025 PDF

Low-voltage surge protective devices-Part 41: Surge protective devices connected to DC low-voltage power systems-Requirements and test methods

$163.93 $327.86 -50%
Product Code: IEC 61643-41
Stock In Stock
Edition: 1.0
Published: 05/2025
Number of Pages: 66
File Size: 1 file, 1 Byte

Available Options

Product Description

Low-voltage surge protective devices – Part 41: Surge protective devices connected to DC low-voltage power systems – Requirements and test methods

Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. This document recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of SPDs when operated as in normal use taking into account the manufacturer's instructions. It also covers abnormal situations that can be expected in practice. This document takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the SPD is connected to the supply mains. However, national wiring rules may differ. If the intended applications of an SPD are covered by different parts of the IEC 61643-x1 series, all relevant parts shall be applied, as far as is reasonable. This part of the IEC 61643 series addresses safety and performance tests for surge protective devices (SPDs) for DC applications in conjunction with IEC 61643-01. This document addresses T1 SPD, T2 SPD and T3 SPD according to IEC 61643-01. IEC 61643-12 addresses the general selection and application principles of SPDs, but focusing on SPDs for AC low-voltage power systems. A separate standard IEC 61643-42 is planned, which is intended to specifically address selection and application principles for SPDs for DC low-voltage power systems.

Scope: This document, together with IEC 61643-01, is applicable to devices for surge protection against indirect and direct effects of lightning or other transient overvoltages. These devices are intended to be connected to DC power circuits and equipment rated up to 1 500 V DC. Performance and safety requirements, tests and ratings are specified in this document. These devices contain at least one nonlinear component and are intended to limit surge voltages and divert surge currents. The test requirements provided by this document are based on the assumption that the SPD is connected to a DC power circuit fed by a power source providing a linear voltage-current characteristic. When the SPD is to be connected to a different kind of source, careful consideration is required. This mainly applies with regard to system and fault conditions to be expected in such a system (e.g. expected short circuit current, TOV-stresses). This document can apply for railway applications, when related product standards do not exist for that area or for certain applications. Based on a risk assessment it might not be necessary to apply all requirements of this document to SPDs designed for specific power applications only, e.g. circuits with a low power capability, circuits supplied by nonlinear sources, circuits with protective separation from the utility supply. NOTE 1 More information on risk assessment is provided in IEC Guide 116. SPDs for PV applications are not covered by this document. NOTE 2 Such SPDs for PV applications are covered by IEC 61643-31. NOTE 3 Other exclusions based on national regulations are possible.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61643-41-2025 PDF

IEC 61643-41-2025 PDF

$163.93 $327.86