IEC 61650-1997 PDF

IEC 61650-1997 PDF

Reliability Data Analysis Techniques - Procedures for Comparison of Two Contant Failure Rates and Two Constant Failure (Event) Intensities

$72.51 $145.02 -50%
Product Code: IEC 61650
Stock In Stock
Edition: 1.0
Published: 08/1997
Number of Pages: 50
File Size: 1 file, 638 Bytes

Available Options

Product Description

Reliability Data Analysis Techniques - Procedures for Comparison of Two Contant Failure Rates and Two Constant Failure (Event) Intensities

Introduction: It is often necessary to compare the reliability characteristics of systems and components when there are technical or other reasons to believe that they might be different. For example, it might be necessary to compare the reliability of items produced by the same manufacturer over different periods of time, or of items produced by different manufacturers. Failure rate and failure intensity are often used as reliability measures. This standard describes procedures for comparing two sets of observations of constant failure rate/constant failure intensity. Simple practical examples are provided to illustrate how the procedures can be applied.

Scope: This International Standard specifies procedures to compare two observed failure rates; failure intensities; rates/intensities of relevant events. The procedures are used to determine whether an apparent difference between the two sets of observations can be considered statistically significant. It is assumed that the time intervals to/between the failures (events) are independent and identically exponentially distributed during the observation period (that is, the accumulated relevant test time). NOTE – This assumption implies that the failure rate/intensity is constant. It is furthermore assumed that there are technical or other reasons to believe that a difference (either an improvement or deterioration) might exist between the observed reliability characteristic of the two sets of items under comparison. Some examples of typical applications are described in 5.4. The methods are designed as hypothesis tests which state, with a specified risk (the significance level), whether the two series of observations belong to the same population or the same process, that is they have the same true mean value. NOTE – Failure rate, which is relevant to non-repaired items, is associated with a distribution of times to failure. Failure intensity, which is relevant to repaired items only, is associated with a point process describing a se- quence of events, for example times between failures on a time axis. The procedures are not restricted to comparison of failure rate/intensity, but can be applied to observations of two series of any relevant events, provided the above assumptions are valid. NOTE – The two series of observations may be of items from the same population, or the same item under different conditions (for example environment and load), or just comparable series of events (for example car accidents on a road). Numerical methods and a graphical procedure are prescribed. The observation periods relevant to the two series do not need to be equal, but if they are, the methods are very simple. – 10 – 61650 © CEI:1997 2 Référence normative Le document normatif suivant contient des dispositions qui, par suite de la référence qui y est faite, constituent des dispositi

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative reference
  • 3 Definitions
  • 4 Symbols
  • 5 Assumptions and area of application
  • 6 Specification of input data
  • 7 Calculation procedures

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61650-1997 PDF

IEC 61650-1997 PDF

$72.51 $145.02