Electrical Apparatus for the Detection and Measurement of Flammable Gases - Part 6: Guide for the Selection, Installation, Use and Maintenance of Apparatus for the Detection and Measurement of Flammable Gases
Introduction: Flammable gas detection apparatus may be used whenever there is the possibility of a hazard to life or property caused by the accumulation of a flammable gas-air mixture. Such apparatus can provide a means of reducing the hazard by detecting the presence of the flammable gas and issuing suitable audible or visual warnings. Gas detectors may also be used to initiate specific precautions (for example plant shutdown, evacuation, operation of fire extinguishing procedures). Apparatus may be used to monitor a gas atmosphere below the lower flammable limit in circumstances where accumulation of gas may result in a concentration of the gas/air mixture to potentially explosive levels.
Scope: 1.1.1 This part of IEC 61779 gives guidance on the selection, installation, use and maintenance of electrically operated group II apparatus for the detection and measurement of flammable gases complying with the requirements of IEC 61779-1 to IEC 61779-5. It is a compilation of practical knowledge to assist the user, and applies to apparatus, instruments and systems that indicate the presence of a flammable or potentially explosive mixture of gas or vapour with air by using an electrical signal from a gas sensor to produce a meter reading, to activate a visual or audible pre-set alarm or other device, or any combination of these. NOTE – When in classified areas, the apparatus should be so installed and used that it is not capable of itself igniting a combustible gas-air mixture. It should therefore comply with the requirements of IEC 60079-10. For the purpose of this standard, flammable gases shall include flammable vapours. 1.1.2 This standard applies only to group II apparatus intended for use in industrial and commercial safety applications, involving areas classified in accordance with IEC 60079-10. For the purpose of this standard, apparatus includes a) fixed apparatus; b) transportable apparatus; and c) portable apparatus. 1.1.3 This standard is not intended to cover the following: a) apparatus intended only for the detection of non-flammable toxic gases; b) apparatus of laboratory or scientific type intended only for analysis or measurement purposes; c) apparatus intended for underground mining applications; d) apparatus intended for applications in explosives processing and manufacture; e) apparatus intended only for process control applications; f) apparatus intended for the detection of a potentially flammable atmosphere resulting from dust or mist in air. 1.2
Contents:
- FOREWORD
- INTRODUCTION
- 1.1 Scope
- 1.2 Normative references
- 3.1 Catalytic sensor
- 3.2 Thermal conductivity sensor
- 3.3 Electromagnetic radiation absorption sensor – usually infrared
- 3.4 Semi-conductor sensor
- 3.5 Electrochemical sensors
- 3.6 Flame ionization detectors (FID)
- 4.1 General
- 4.2 Selection criteria
- 4.3 Miscellaneous factors affecting selection of apparatus
- 5.1 Nature of a release
- 5.2 Outdoor sites and open structures
- 5.3 Buildings and enclosures
- 5.4 Environmental considerations
- 6.1 Basic considerations for the installation of fixed systems
- 6.2 Location of sensors
- 6.3 Installation of sensors
- 6.4 Timing of installation during construction operations
- 6.5 Safety in fixed systems
- 6.6 Environmental conditions
- 6.7 Sample lines
- 6.8 Access for calibration and maintenance
- 6.9 Commissioning
- 6.10 Operating instructions, plans and records