Industrial communication networks – Profiles – Part 5-11: Installation of fieldbuses – Installation profiles for CPF 11
Introduction: This International Standard is one of a series produced to facilitate the use of communication networks in industrial control systems. IEC 61918:2013 provides the common requirements for the installation of communication networks in industrial control systems. This installation profile standard provides the installation profiles of the communication profiles (CP) of a specific communication profile family (CPF) by stating which requirements of IEC 61918 fully apply and, where necessary, by supplementing, modifying, or replacing the other requirements (see Figure 1). For general background on fieldbuses, their profiles, and relationship between the installation profiles specified in this standard see IEC 61158-1. Each CP installation profile is specified in a separate annex of this standard. Each annex is structured exactly as the reference standard IEC 61918 for the benefit of the persons representing the roles in the fieldbus installation process as defined in IEC 61918 (planner, installer, verification personnel, validation personnel, maintenance personnel, administration personnel). By reading the installation profile in conjunction with IEC 61918, these persons immediately know which requirements are common for the installation of all CPs and which are modified or replaced. The conventions used to draft this standard are defined in Clause 5. The provision of the installation profiles in one standard for each CPF (for example IEC 61784-5-11 for CPF 11), allows readers to w
Scope: This part of IEC 61784-5 specifies the installation profiles for CPF 11 (TCnet1). The installation profiles are specified in the annexes. These annexes are read in conjunction with IEC 61918:2013.
Contents:
- FOREWORD
- INTRODUCTION
- Scope