IEC 61788-11-2011 PDF

IEC 61788-11-2011 PDF

Superconductivity-Part 11: Residual resistance ratio measurement-Residual resistance ratio of Nb3Sn composite superconductors

$100.88 $201.76 -50%
Product Code: IEC 61788-11
Stock In Stock
Edition: 2.0
Published: 07/2011
Number of Pages: 48
File Size: 1 file, 532 Bytes

Available Options

Product Description

Superconductivity – Part 11: Residual resistance ratio measurement – Residual resistance ratio of Nb3Sn composite superconductors

Introduction: Copper or aluminium is used as stabilizer material in multifilamentary Nb3Sn superconductors and works as an electrical shunt when the superconductivity is interrupted. It also contributes to recovery of the superconductivity by conducting the heat generated in the superconductor to the surrounding coolant. The resistivity of copper used in the composite superconductor in the cryogenic temperature region is an important quantity which influences the stability of the superconductor. The residual resistance ratio is defined as a ratio of the resistance of the superconductor at room temperature to that just above the superconducting transition. In this International Standard, the test method for the residual resistance ratio of Nb3Sn composite superconductors is described. The curve method is employed for the measurement of the resistance just above the superconducting transition. Other methods are described in Clause A.3.

Scope: This part of IEC 61788 covers a test method for the determination of the residual resistance ratio (RRR) of Nb3Sn composite superconductors. This method is intended for use with superconductor specimens that have a monolithic structure with rectangular or round cross- section, RRR less than 350 and cross-sectional area less than 3 mm2, and have received a reaction heat-treatment. Ideally, it is intended that the specimens be as straight as possible; however, this is not always the case, thus care must be taken to measure the specimen in its as received condition. All measurements are done without an applied magnetic field. The method described in the body of this standard is the “reference” method and optional acquisition methods are outlined in Clause A.3.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-11-2011 PDF

IEC 61788-11-2011 PDF

$100.88 $201.76