IEC 61788-15 (REDLINE + STANDARD)-2026 PDF

IEC 61788-15 (REDLINE + STANDARD)-2026 PDF

Superconductivity - Part 15: Electronic characteristic measurements - Intrinsic surface impedance of superconductor films at microwave frequencies

$407.31 $814.61 -50%
Product Code: IEC 61788-15 (REDLINE + STANDARD)
Stock In Stock
Edition: 2.0
Published: 03/2026
Number of Pages: 142
File Size: 1 file, 4 MB

Available Options

Product Description

Superconductivity - Part 15: Electronic characteristic measurements - Intrinsic surface impedance of superconductor films at microwave frequencies

Introduction: Since the discovery of high TC superconductors (HTS), extensive researches have been performed worldwide on electronic applications and large-scale applications with HTS filter subsystems based on YBa2Cu3O7-δ (YBCO) having already been commercialized [1]2. Merits of using HTS films for microwave devices such as resonators, filters, antennas, delay lines, etc., include i) microwave losses from HTS films could be extremely low and ii) no signal dispersion on transmission lines made of HTS films due to extremely low microwave intrinsic surface resistance (RS) [2] and frequency-independent penetration depth (λ) of HTS films, respectively. In this regard, when it comes to designing of HTS-based microwave devices, it is important to measure the intrinsic surface impedance (ZS) of HTS films with ZS = RS + jXS and XS = ωμ0λ (here ω and μ0 denote the angular frequency and the permeability of vacuum, respectively, XS, the intrinsic surface reactance, and XS = ωμ0λ is valid at temperatures not too close to the critical temperature TC of HTS films). Various reports have been made on measuring the RS of HTS films at microwave frequencies with the typical RS of HTS films as low as 1/100 to 1/50 of that of oxygen-free high-purity conductivity copper (OFHC) at 77 K and 10 GHz. The RS of conventional superconductors such as niobium (Nb) could be easily measured by using Nb cavities by converting the resonator quality factor (Q) to the RS of Nb. However, such conventional measurement method co

Scope: This part of IEC 61788 describes measurements of the intrinsic surface impedance (ZS) of HTS films at microwave frequencies by a modified two-resonance mode dielectric resonator method [14], [15]. The object of measurement is to obtain the temperature dependence of the intrinsic surface impedance, ZS, at the resonant frequency f0. The frequency and thickness range and the measurement resolution for the intrinsic ZS of HTS films are as follows: frequency: up to 40 GHz; film thickness: greater than 50 nm; measurement resolution: 0,01 mΩ at 10 GHz. It is crucial that the intrinsic ZS data at the measured frequency, and that scaled to 10 GHz be reported for comparison, assuming the f2 rule for the intrinsic surface resistance, RS (f < 40 GHz), and the f rule for the intrinsic surface reactance, XS for comparison, shall be reported.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 1 In this Annex A, numerals in square brackets refer to Clause A.8, Reference documents.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-15 (REDLINE + STANDARD)-2026 PDF

IEC 61788-15 (REDLINE + STANDARD)-2026 PDF

$407.31 $814.61