IEC 61788-23 (REDLINE + STANDARD)-2024 PDF

IEC 61788-23 (REDLINE + STANDARD)-2024 PDF

Superconductivity-Part 23: Residual resistance ratio measurement-Residual resistance ratio of cavity-grade Nb superconductors

$225.09 $450.18 -50%
Product Code: IEC 61788-23 (REDLINE + STANDARD)
Stock In Stock
Edition: 3.0
Published: 05/2024
Number of Pages: 94
File Size: 1 file, 1.8 MB

Available Options

Product Description

Superconductivity – Part 23: Residual resistance ratio measurement – Residual resistance ratio of cavity-grade Nb superconductors

Introduction: High-purity niobium is the chief material used to make superconducting radio-frequency cavities. Similar grades of niobium may can be used in the manufacture of superconducting wire. Procurement of raw materials and quality assurance of delivered products often use the residual resistance ratio (RRR) to specify or assess the purity of a metal. RRR is defined for non- superconducting metals as the ratio of electrical resistance measured at room temperature (293 K) to the resistance measured for the same specimen at low temperature (~4,2 K). The low-temperature value is often called the residual resistance. Higher purity is associated with higher values of RRR. Niobium presents special problems due to its transformation to a superconducting state at ~9 K, so DC electrical resistance is effectively zero below this temperature. The definition above would then yield an infinite value for RRR. This document describes a test method to determine the residual resistance value by using a plot of the resistance to temperature as the test specimen is gradually warmed through the superconducting transition in the absence of an applied magnetic field. This results in a determination of the residual resistance at just above superconducting transition, ~10 K, from which RRR is subsequently determined. International Standards also exist to determine the RRR of superconducting wires. In contrast to superconducting wires, which are usually a composite of a superconducting material and a non-sup

Scope: This part of IEC 61788 addresses a test method for the determination of the residual resistance ratio (RRR), rRRR, of cavity-grade niobium. This method is intended for high-purity niobium grades with 150 < rRRR < 600. The test method is valid for specimens with rectangular or round cross-section, cross-sectional area greater than 1 mm2 but less than 20 mm2, and a length not less than 10 nor more than 25 times the width or diameter.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-23 (REDLINE + STANDARD)-2024 PDF

IEC 61788-23 (REDLINE + STANDARD)-2024 PDF

$225.09 $450.18