IEC 61810-2-1-2017 PDF

IEC 61810-2-1-2017 PDF

Electromechanical elementary relays-Part 2-1: Reliability-Procedure for the verification of B10 values

$72.51 $145.02 -50%
Product Code: IEC 61810-2-1
Stock In Stock
Edition: 2.0
Published: 05/2017
Number of Pages: 38
File Size: 1 file, 510 Bytes

Available Options

Product Description

Electromechanical elementary relays – Part 2-1: Reliability – Procedure for the verification of B10 values

Introduction: Based on the general provisions of IEC 61810-2, this part of IEC 61810 specifies reliability test procedures for electromechanical elementary relays where enhanced requirements for the verification of reliability apply. A type test is passed and then confirmed by routine tests with specified periodicity. This document describes how figures for B10 (the mean number of cycles until 10 % of the relays have failed) are derived from these life tests performed with representative relay samples. In particular when electromechanical elementary relays are intended to be incorporated in safety-related control systems of machinery in accordance with IEC 62061 and ISO 13849-1, the mean time to dangerous failure (MTTFd) is a measure that can be taken into account when assessing the probability of dangerous failure of the safety function concerned. Although a component failure cannot be defined as “dangerous” unless the detailed application is known, it is common to consider a failure mode that is likely to result in danger in a typical application of the component, and to refer to this failure mode as a “dangerous failure”. The MTTFd then becomes the expectation of the mean time to failure in this "dangerous" mode. For the calculation of MTTFd for electromechanical relays, the data provided by the manufacturer for B10D can be used (see Clause C.4 of ISO 13849-1:2015). Electromechanical elementary relays with forcibly guided (mechanically linked) contacts offer the possibility of a high di

Scope: This part of IEC 61810 specifies reliability test procedures for electromechanical elementary relays when enhanced requirements for the verification of reliability apply. Particular provisions are given for relays incorporated in safety-related control systems of machinery in accordance with IEC 62061 and ISO 13849-1. For such relays, B10 values for dangerous failures (B10D values) are derived from the tests specified in this document.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61810-2-1-2017 PDF

IEC 61810-2-1-2017 PDF

$72.51 $145.02