IEC 61850-9-1-2003 PDF

IEC 61850-9-1-2003 PDF

Communication networks and systems in substations Part 9-1: Specific Communication Service Mapping (SCSM) Sampled values over serial unidirectional multidrop point to point link

$132.41 $264.81 -50%
Product Code: IEC 61850-9-1
Stock In Stock
Edition: 1.0
Published: 05/2003
Number of Pages: 36
File Size: 1 file, 180 Bytes

Available Options

Product Description

Communication networks and systems in substations Part 9-1: Specific Communication Service Mapping (SCSM) Sampled values over serial unidirectional multidrop point to point link

Introduction: This part of IEC 61850 applies to electronic current and voltage transformers (ECT and EVT) with a digital output via a merging unit, for use with electronic measuring instruments and electronic protective devices. The transformer technology can be based on optical arrangements equipped with electronic components, on air core coils (with or without a built-in integrator) or, on iron core coils with integrated burden and used as a current to voltage converter, alone or equipped with electronic components. For digital output, this standard takes into account a point to point connection from the merging unit to electronic measuring instruments and electronic devices. This mapping allows interoperability between devices from different manufacturers. This standard does not specify individual implementations or products, nor does it constrain the implementation of entities and interfaces within a computer system. This standard specifies the externally visible functionality of implementations. Reading Guide The point to point transformer interface as defined here is based on the concepts described in IEC 60044-8. This standard extends this concept and proposes an alternative link layer to provide a solution for transmitting sampled measured values via Ethernet based interfaces. For the definition and measurement of the accuracy, synchronisation methods, data rates etc. of the transformers, refer to IEC 60044-8. This document can best be understood if the reader is thoroughly familia

Scope: This part of IEC 61850 specifies the specific communication service mappings for the communication between bay and process level and it specifies a mapping on a serial unidirectional multidrop point to point link in accordance with IEC 60044-8. This part of IEC 61850 specifies a mapping of the abstract service for the transmission of sampled values (as defined in IEC 61850-7-2) on a serial unidirectional multidrop point to point link in accordance with IEC 60044-8. It applies to the communication between merging units of electronic current (ECT) or voltage-transformers (EVT) and bay devices such as protection relays. If higher requirements on sampling rate, further sampled measured value data sets in addition to the universal data set, inter-bay communication and synchronisation apply, these will be covered by IEC 61850-9-23. Figure 1 shows the schematics of this interface. Merging unit Line protection Bay controller Ethernet controller Multiple ports Ethernet controller Ethernet controller Proprietary link Proprietary link Serial unidirectional multidrop point to point link Synchronisation, monitoring, test and configuration interfaces Binary inputs IEC 812/03 Figure 1 – Example for the use of the serial unidirectional multidrop point to point link ——————— 3 Under consideration. – 8 – 61850-9-1  IEC:2003(E)

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61850-9-1-2003 PDF

IEC 61850-9-1-2003 PDF

$132.41 $264.81