IEC 61869-11-2017 PDF

IEC 61869-11-2017 PDF

Instrument transformers-Part 11: Additional requirements for low-power passive voltage transformers

$163.93 $327.86 -50%
Product Code: IEC 61869-11
Stock In Stock
Edition: 1.0
Published: 12/2017
Number of Pages: 72
File Size: 0 files

Available Options

Product Description

Instrument transformers – Part 11: Additional requirements for low-power passive voltage transformers

Introduction: Low-power passive voltage transformers are based on the voltage divider principle. They can be built for example as resistive dividers, capacitive dividers or resistive-capacitive dividers. Annex 11C shows the schematic diagram of the different dividers. According to a general block diagram given in Figure 601 of IEC 61869-6:2016, the low-power passive voltage transformers do not use an active primary converter (i.e. without any active electronic component); therefore, there is no need for primary power supply. Additionally, neither the secondary converter nor the secondary power supply is used. The general block diagram of a low-power passive voltage transformer is given in Figure 1101. The applied technology decides which part is necessary for the realization of a low-power passive voltage transformer, i.e. it is not necessary that the transmitting cable or primary converter described in Figure 1101 be included in the low-power passive voltage transformer. Figure 1101 – General block diagram of a single-phase low-power passive voltage transformer Primary voltage sensor Transmitting cable Passive primary converter IEC

Scope: This part of IEC 61869 is a product standard and covers only additional requirements for low- power passive voltage transformers (passive LPVT). The product standard for low-power passive voltage transformers is composed of IEC 61869-1, along with IEC 61869-6 and this document with specific requirements. This document is applicable to newly manufactured low-power passive voltage transformers with analogue output having rated frequencies from 15 Hz to 100 Hz for use with electrical measuring instruments or electrical protective devices. This document covers low-power passive voltage transformers used for measurement or protection and low-power passive voltage transformers used for both measurement and protection. Low-power passive voltage transformers have analogue output only (for digital output or for technology using any kind of active electronic components refer to future IEC 61869-72). Such low-power passive voltage transformers can include the secondary signal cable (transmitting cable). The secondary voltage of the low-power passive voltage transformer is proportional to the primary voltage. Derivative output signals are not within the scope of this document.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 5.1101 Standard values of rated voltages
  • 5.1102 Standard values of rated voltage factor FV
  • 6.601 Requirements for optical transmitting system and optical output link
  • 6.602 Requirements for electrical transmitting system and electrical wires for
  • 6.603 Signal-to-noise ratio
  • 6.604 Failure detection and maintenance announcement
  • 6.605 Operability
  • 6.606 Reliability and dependability
  • 6.1101 Transient response requirements
  • 6.1102 Voltage limitation device requirements
  • 601 Information to be given with enquiries, tenders and orders
  • 601.1 Designation
  • 601.2 Dependability

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61869-11-2017 PDF

IEC 61869-11-2017 PDF

$163.93 $327.86