IEC 61869-14-2018 PDF

IEC 61869-14-2018 PDF

Instrument transformers-Part 14: Additional requirements for current transformers for DC applications

$186.00 $371.99 -50%
Product Code: IEC 61869-14
Stock In Stock
Edition: 1.0
Published: 07/2018
Number of Pages: 90
File Size: 1 file, 1 Byte

Available Options

Product Description

Instrument transformers – Part 14: Additional requirements for current transformers for DC applications

Introduction: General This document applies to current transformers intended to be used in DC applications with at least one of the following functions: measure DC current (with significant harmonics); withstand DC voltage. Depending on the position of the current transformer on the DC system, different kinds of application exist, which are briefly described below, together with the approximate voltage or current wave shape. Line-commutated converters (LCC) Line-commutated converters (LCC) are based on thyristor converters (see Figure 1401). They are characterized by a single direction of current flow, and a voltage polarity reversal possibility. Significant voltage and current harmonics exist up to frequencies of about 3 kHz to 4 kHz. Figure 1401 – Example of LCC scheme We distinguish three different current-measurement functions: CT1: measurement of the current at the AC side of the converter; CT2: measurement of the current at the DC side of the converter; CT3: measurement of the current in the DC filter. Table 1401 gives an overview of the current and voltage waveshapes as well as the main characteristics of the different applications of the CT.

Scope: This part of IEC 61869 provides all requirements specific to current transformers to be used in DC applications (DCCTs), whatever the technology used. The output signal can be analogue or digital. It is applicable to newly manufactured current transformers used for measuring, protection and/or control applications in DC power systems with a rated voltage above 1,5 kV. The general configuration of a single-pole low-power instrument transformer is described in Figure 601 of IEC 61869-6:2016. The DCCTs intended for current measurement in the transistor branch of the VSC valve (referred to as CT4a and CT4b in Figure 1403 and Table 1402) are not covered by this document, and will be considered in a future revision.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61869-14-2018 PDF

IEC 61869-14-2018 PDF

$186.00 $371.99