IEC 61892-1 (REDLINE + STANDARD)-2019 PDF

IEC 61892-1 (REDLINE + STANDARD)-2019 PDF

Mobile and fixed offshore units-Electrical installations-Part 1: General requirements and conditions

$278.68 $557.36 -50%
Product Code: IEC 61892-1 (REDLINE + STANDARD)
Stock In Stock
Edition: 4.0
Published: 04/2019
Number of Pages: 116
File Size: 1 file, 1.9 MB

Available Options

Product Description

Mobile and fixed offshore units – Electrical installations – Part 1: General requirements and conditions

Introduction: IEC 61892 forms a series of International Standards is intended to enable for safety in the design, selection, installation, maintenance and use of electrical equipment for the generation, transmission, storage, distribution and utilization of electrical energy for all purposes in offshore units which are used for the purpose of exploration or exploitation of petroleum resources. This part of IEC 61892 incorporates and coordinates, as far as possible, existing rules and forms a code of interpretation, where applicable, of the requirements of the International Maritime Organization (IMO), and constitutes a guide for future regulations which may be prepared and a statement of practice for offshore unit owners, constructors designers, installers and appropriate organizations. This document is based on equipment solutions and practices methods which are in current use, but it is not intended in any way to impede the development of new or improved techniques. The ultimate aim has been to produce a set of International Standards exclusively for the offshore petroleum industry. In this revision, voltage limitations have been removed. However, voltage limitations may be given in the referenced equipment standards. The removal of voltage limitations is considered necessary due to the interconnection of, and supply from shore to offshore units. In such cases, transmission voltages up to 132 kV AC and 150 kV DC are used and higher voltages are being planned. The IEC 61892 series aims to

Scope: This part of IEC 61892 contains provisions for is applicable to electrical installations and equipment in mobile and fixed offshore units, including pipeline, pumping or "pigging" stations, compressor stations and exposed location single buoy moorings, used in the offshore petroleum industry for drilling, production, accommodation, processing, storage and offloading purposes. It applies to all installations, whether permanent, temporary, transportable or hand-held, to AC installations up to and including 35 000 V and DC installations up to and including 1 500 V (AC and DC voltages are nominal values) without any voltage level limitation. Referenced equipment standards may give voltage level limitations. This document specifies requirements such as those concerning environmental conditions, power supply characteristics, location of electrical equipment in units, protection against external influences, protection against electrical shock, and ignition source control. This document gives information and guidance on topics such as cold climate protection, and surface treatment and protective painting system. This document does not apply either to fixed equipment for medical purposes or to the, electrical installations of tankers, and control of ignition sources other than those created by electrical equipment. NOTE 1 For medical rooms, IEC 60364-7-710 provides more information specific requirements. Requirements for tankers are given in IEC 60092-502. NOTE 2 Guidance on protection of non-electrical equipment can be found in ISO 80079-36, ISO 80079-37 and IMO 2009 MODU Code, 6.7.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61892-1 (REDLINE + STANDARD)-2019 PDF

IEC 61892-1 (REDLINE + STANDARD)-2019 PDF

$278.68 $557.36