Mobile and fixed offshore units – Electrical installations – Part 5: Mobile units
Introduction: IEC 61892 forms a series of International Standards for safety in the design, selection, installation, maintenance and use of electrical equipment for the generation, transmission, storage, distribution and utilization of electrical energy for all purposes in offshore units which are used for the purpose of exploration or exploitation of petroleum resources. This part of IEC 61892 incorporates and coordinates, as far as possible, existing rules and forms a code of interpretation, where applicable, of the requirements of the International Maritime Organization (IMO), and constitutes a guide for future regulations which may be prepared and a statement of practice for offshore unit owners, designers, installers and appropriate organizations. This document is based on solutions and methods which are in current use, but it is not intended to impede development of new or improved techniques. In this revision, voltage limitations have been removed. However, voltage limitations may be given in the referenced equipment standards. The removal of voltage limitations is considered necessary due to the interconnection of, and supply from shore to offshore units. In such cases transmission voltages up to 132 kV AC and 150 kV DC are used and higher voltages are being planned. The IEC 61892 series aims to constitute a set of International Standards for the offshore petroleum industry, but it is not intended to prevent their use beyond petroleum installations.
Scope: This part of IEC 61892 specifies additional characteristics for electrical installations in mobile units. It applies to installations that depend on buoyancy, such as column-stabilized units (semisubmersible units), ship- or barge-type units as well as self-elevating units. It specifies additional characteristics for such units, used during transfer from one location to another and for drilling, production, accommodation, processing, storage and offloading purposes. It applies to all installations, whether permanent, temporary, transportable or hand-held, to AC installations and DC installations without any limitation on voltage level. Referenced equipment standards may give voltage level limitations. This document specifies requirements such as those concerning environmental conditions, limits of inclination for the unit where the equipment is required to operate, bilge pumps, navigation and obstruction lights, steering gear, ballast system, jacking systems, and anchoring systems. For electric propulsion, reference is made to IEC 60092-501. For dynamic positioning systems, reference is made to relevant IMO requirements. This document does not apply to fixed equipment for medical purposes, electrical installations of tankers, and control of ignition sources other than those created by electrical equipment. NOTE 1 For medical rooms, IEC 60364-7-710 provides specific requirements. Requirements for tankers are given in IEC 60092-502. NOTE 2 Guidance on protection of non-electrical equipment can be found in ISO 80079-36, ISO 80079-37 and IMO 2009 MODU Code, 6.7. NOTE 3 Attention is drawn to further requirements concerning electrical installations on such mobile offshore units contained in the IMO MODU Code. – 8 – IEC 61892-5:2019 © IEC 2019
Contents:
- FOREWORD
- INTRODUCTION
- Scope