IEC 61969-1 (REDLINE + STANDARD)-2023 PDF

IEC 61969-1 (REDLINE + STANDARD)-2023 PDF

Mechanical structures for electrical and electronic equipment-Outdoor enclosures-Part 1: Design guidelines

$85.75 $171.50 -50%
Product Code: IEC 61969-1 (REDLINE + STANDARD)
Stock In Stock
Edition: 4.0
Published: 02/2023
Number of Pages: 46
File Size: 1 file

Available Options

Product Description

Mechanical structures for electrical and electronic equipment – Outdoor enclosures – Part 1: Design guidelines

Introduction: This part of IEC 61969 is intended as a generic guide for the development of further parts within this series of standards, and it provides design guidelines for outdoor enclosures. The products covered by the IEC 61969 series are empty enclosures for outdoor locations, to be equipped with application-specific combinations of electrical and electronic equipment, and to be used at non-weatherprotected locations above ground. The IEC 61969 series consists of: a design guidelines general part: IEC 61969-1; a coordination dimensions standard: IEC 61969-2; an environmental requirements and tests, safety aspects standard: IEC 61969-3. IEC 61969-2 and IEC 61969-3 should be read in conjunction with this document.

Scope: This part of IEC 61969 contains design guidelines for outdoor enclosures for electrical and electronic equipment and is applicable over a wide field of mechanical, electromechanical and electronic equipment and its installation where a modular design is used. The objectives of this document are: to provide an overview of specifications for enclosures focused on requirements for outdoor applications for stationary use at non-weatherprotected locations, and to achieve product integrity under outdoor conditions and to ease product selection for the sourcing of outdoor enclosures from different vendors. These enclosures are considered to contain any equipment and provide protection for the outdoor installed facilities against unwanted environmental impacts. The installed equipment can be, but is not limited to, subracks or chassis in accordance with the IEC 60917 series or IEC 60297 series. A typical outdoor enclosure is shown in Figure 1. Figure 1 – Typical outdoor enclosure IEC 61969-1:2023 RLV © IEC 2023 – 7 –

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61969-1 (REDLINE + STANDARD)-2023 PDF

IEC 61969-1 (REDLINE + STANDARD)-2023 PDF

$85.75 $171.50