Mechanical structures for electrical and electronic equipment – Outdoor enclosures – Part 3: Environmental requirements, tests and safety aspects
Introduction: The products covered by IEC 61969 series are empty enclosures for outdoor locations, to be equipped with application-specific combinations of electrical and electronic equipment, and to be used at non-weatherprotected locations above ground. IEC 61969 series consists of: a design guidelines general part: IEC 61969-1; a coordination dimensions standard: IEC 61969-2; an environmental requirements and tests, safety aspects standard: IEC 61969-3. This document provides basic environmental requirements and tests, as well as safety aspects, to be used for outdoor enclosures in absence of local regulatory documents, or of application- specific environmental test requirements. This document provides manufacturers and users of generic outdoor enclosures with minimum performance compliance criteria. The thermal management solution depends on the specific environment of the outdoor enclosure. Since forced air heat dissipation and acoustic noise are closely related, noise limitations are typically defined by local regulatory documents. It is responsibility of the outdoor enclosure vendor to provide a solution for thermal management within the local regulatory noise limitations.
Scope: This part of IEC 61969 specifies a set of basic environmental requirements and tests, as well as safety aspects for outdoor enclosures for electrical and electronic equipment, under conditions of non-weatherprotected locations above ground. The purpose of this document is to define a minimum level of environmental performance in order to meet requirements of storage, transport and final installation. The intention is to establish basic environmental performance criteria for outdoor enclosure compliance.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Thermal management
- 11 Acoustic noise emission