Maritime Navigation and Radiocommunication Equipment and Systems - Part 1: Shipborne Automatic Transponder System Installation Using VHF Digital Selective Calling (DSC) Techniques - Operational and Performance Requirements, Methods of Testing and Required Test Results
Introduction: In 1995 the IMO instigated work on the development of performance standards for a shipborne automatic identification system (AIS) using VHF digital selective calling (DSC) techniques. These performance standards were developed into a draft resolution which was expected to be adopted by the IMO Maritime Safety Committee. However, there were objections to this on the grounds that some requirements for AIS were not met by the draft resolution. The outcome has been that IMO has now developed further performance standards for a “Universal AIS” as a resolution which was adopted by the IMO Maritime Safety Committee in May 1998 as MSC. 74(69) annex 3. During this period, some countries have gone ahead and implemented operational systems based upon the original IMO draft performance standards for AIS. There is therefore a need for a technical testing standard for such equipment. At their plenary meeting in September 1997, technical committee 80 came to the following decisions: a draft technical standard which had been prepared on the basis of the original IMO performance standards would go ahead with the reference 61993-1, but would not directly refer to any IMO resolution for AIS; work would commence at the earliest opportunity on preparing a technical standard for a “Universal AIS” based rigorously upon the IMO resolution MSC.74(69) and a new recommendation ITU-R M.1371. This standard would have the reference 61993-2.
Scope: This part of IEC 61993 specifies the performance requirements, technical characteristics, operational requirements, methods of testing and required test results for shipborne automatic transponder system installations using VHF digital selective calling (DSC) techniques and is associated with IEC 60945. When a requirement in this standard is different from IEC 60945, the requirement in this standard shall take precedence. The shipborne transponder installation is intended to assist in the efficient operation of ship- reporting systems and vessel traffic services (VTS) by enabling operators to identify, poll and automatically locate and track ships when they are approaching, entering and sailing within the limits of a ship-reporting system. The system may also be used for the identification of ships by a ship and ships by aircraft. A description of the system is given in annex C. This standard incorporates the technical characteristics included in ITU-R Recommendation M.825 for transponder systems using DSC and the technical characteristics included in ITU-R Recommendation M.489 for VHF radiotelephone equipment; incorporates the technical characteristics of DSC equipment and the operational procedures for its use contained in Recommendations ITU-R M.493 and ITU-R M.541; incorporates applicable parts of the performance standards of IMO Resolution A.803 for shipborne VHF radio installations; takes account of IMO Resolution A.694 for general requirements; and conforms with the International Telecommunication Union (ITU) Radio Regulations where applicable. This standard for a transponder system is not intended to meet the requirements for a universal automatic identification system (AIS), as detailed in IMO Resolution MSC.74(69) annex 3. NOTE – All text in this standard whose meaning complies with that in the normative references, namely IMO Resolution A.803(19) and ITU-R Recommendations M.825, M.489, M.493 and M.541 is followed by a reference to the source (number of IMO Resolution or ITU-R Recommendation and paragraph number) in brackets. 61993-1 © IEC(E):1999 – 7 –
Contents:
- FOREWORD
- INTRODUCTION
- Scope