IEC 62005-9-1-2015 PDF

IEC 62005-9-1-2015 PDF

Fibre optic interconnecting devices and passive components - Reliability - Part 9-1: Qualification of passive optical components

$186.00 $371.99 -50%
Product Code: IEC 62005-9-1
Stock In Stock
Edition: 1.0
Published: 06/2015
Number of Pages: 90
File Size: 1 file, 1 Byte

Available Options

Product Description

Fibre optic interconnecting devices and passive components - Reliability - Part 9-1: Qualification of passive optical components

Introduction: Qualification reliability standards define the conditions for a set of stress tests, the passing of which suggests an acceptable level of reliability in the referenced performance categories and operating service environments. Upon passing, the specific product tested is called qualified to that standard. The results of these tests are attribute data, i.e. pass or fail. True reliability prediction and quantification requires significantly greater testing. This International Standard is meant to be a general document that can be applied to all passive optical components, except connectors. As such, it does not and cannot cover every possible component and application. Its application to electrically assisted non-active components such as optical switches is under study. The stress tests are specific and explicitly defined to establish consistency. The measurements and pass/fail criteria are not explicitly stated in this standard; however, guidance is given in the relevant clause to establish reasonable parameters and values. Explicit reporting requirements are defined which include written justifications and technical support for all selected measurements and pass/fail criteria.

Scope: This part of IEC 62005 establishes a general reliability qualification program that applies to all passive fibre optic components except connectors and connector assemblies, the passing of which, suggests a minimum level of reliability assurance and allows that specific device to be called qualified to this standard. The objectives of this International Standard are as follows: to specify the requirements for a general reliability qualification standard (RQS) for passive optical components; to give direction to the supplier and to the end user on the production and purchase of passive optical components to meet and verify reliability qualification standards for certain specified service environments; to give the minimum list of reliability qualification stress tests and conditions; to establish guidance for the selection of appropriate measurements and pass/fail criteria; to give relevant references; and to establish the minimum reporting requirements. This standard defines a series of stress tests, their severity, sequences, quantities of devices under the test (DUT), acceptance criteria, and reporting requirements. It also gives guidelines to selecting appropriate measurements and pass/fail criteria.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62005-9-1-2015 PDF

IEC 62005-9-1-2015 PDF

$186.00 $371.99