IEC 62026-1 (REDLINE + STANDARD)-2019 PDF

IEC 62026-1 (REDLINE + STANDARD)-2019 PDF

Low-voltage switchgear and controlgear-Controller-device interfaces (CDIs)-Part 1: General rules

$85.75 $171.50 -50%
Product Code: IEC 62026-1 (REDLINE + STANDARD)
Stock In Stock
Edition: 3.0
Published: 05/2019
Number of Pages: 46
File Size: 1 file

Available Options

Product Description

Low-voltage switchgear and controlgear – Controller-device interfaces (CDIs) – Part 1: General rules

Introduction: The class of controller-device interfaces (CDIs) covered in this document includes industrial CDIs for control systems, factory automation and process automation. Industrial CDIs have proliferated to meet specific user needs, but no single CDI meets all needs. The reason for multiple solutions is the wide range of physical, usage, information content and configuration requirements. The physical requirements have resulted in CDIs with widely differing signal and line conditioning mechanisms in order to meet distance, node count and environmental considerations. While there is wide variation in CDI technologies, there are common components, interfaces and environmental requirements that are specified by this document. Standardized definitions of these common CDI requirements assist the user in comparing and selecting technologies to match the distance, node count, throughout and installation requirements for a specific application. This document simplifies the CDI selection process by providing a common structure for generating a specific CDI’s IEC standard while also allowing specific interface features and capabilities to be included. Clauses 1 4 to 8 contain the outline of general requirements that the CDI’s IEC standard identifies. Clause 9 contains the test specification. Standardization of CDI aspects also simplifies the task of writing the software for the higher layer functions of industrial control systems, such as supervisory control, operator interface and control st

Scope: This part of IEC 62026 applies to interfaces between low-voltage switchgear, controlgear, and controllers (e.g. programmable controllers, personal computers, etc.). This document does not apply to higher level industrial communication networks that have become known as fieldbuses and are considered by IEC subcommittee 65C. The purpose of this document is to harmonize and define rules, components and requirements of a general nature applicable to industrial CDIs. Those features of the various CDI standards which can be considered as general have therefore been brought together in this document. For each CDI, two main documents are necessary to determine all requirements and tests: a) this document, referred to as “IEC 62026-1” in the relevant CDI parts covering the various types of CDIs; b) the specific CDI part of the IEC 62026 series. A specific CDI part may omit a general requirement if it is not applicable, or it may add to it if it is inadequate in the particular case, but it should not deviate from the requirement unless there is substantial technical justification. NOTE Product-specific requirements for products incorporating a CDI are given in the relevant product standards. These requirements apply in addition to those given in this document.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62026-1 (REDLINE + STANDARD)-2019 PDF

IEC 62026-1 (REDLINE + STANDARD)-2019 PDF

$85.75 $171.50