IEC 62031 (REDLINE + STANDARD)-2018 PDF

IEC 62031 (REDLINE + STANDARD)-2018 PDF

LED modules for general lighting-Safety specifications

$171.50 $342.99 -50%
Product Code: IEC 62031 (REDLINE + STANDARD)
Stock In Stock
Edition: 2.0
Published: 03/2018
Number of Pages: 78
File Size: 1 file

Available Options

Product Description

LED modules for general lighting – Safety specifications

Introduction: The first edition of a safety standard for LED modules for general lighting applications acknowledges the need for relevant tests for this new source of electrical light, sometimes called “solid state lighting”. The provisions in the standard represent the technical knowledge of experts from the fields of the semiconductor industry and those of the traditional electrical light sources. Two types of LED modules are covered: with integral and external control gear.

Scope: This document specifies general and safety requirements for light-emitting diode (LED) modules: non-integrated LED modules without integral control gear (LEDni modules) and semi- integrated LED modules (LEDsi modules) for operation under constant voltage, constant current or constant power; self-ballasted Integrated LED modules (LEDi modules) for use on DC supplies up to 250 V or AC supplies up to 1 000 V at 50 Hz or 60 Hz. LED modules within the scope of this document can be integral, built-in or independent. This document is not applicable for LED lamps. NOTE 1 The safety requirements for separate control gear are specified in IEC 61347-2-13. The performance requirements for separate control gear LED modules are specified in IEC 62384 IEC 62717. NOTE 2 Requirements for LED modules with integrated control gear and equipped with a lamp cap (self-ballasted lamp), intended for mains voltage general lighting service retrofit applications (thereby replacing existing lamps with identical lamp caps) are specified in IEC 60968 (an amendment to the present edition or a new edition with extended scope is in preparation). Requirements for LED modules with integrated control gear and equipped with a lamp cap (self-ballasted lamp), intended for non-mains voltage general lighting service retrofit applications (thereby replacing existing lamps with identical lamp caps) are under consideration. NOTE 3 Where in the requirements of this standard both types of LED modules, with and without integral control gear, are addressed, the word “modules” is used instead. Where only the expression “LED module(s)” is used, it is understood to refer to the type without integral control gear.

Contents:

  • INTRODUCTION
  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62031 (REDLINE + STANDARD)-2018 PDF

IEC 62031 (REDLINE + STANDARD)-2018 PDF

$171.50 $342.99