Electricity metering equipment – General requirements, tests and test conditions – Part 31: Product safety requirements and tests
Introduction: The IEC addresses safety aspects by establishing basic, group and product safety publications. A basic safety publication covers a specific safety-related matter, applicable to many electrotechnical products. It is primarily intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. It is not intended for use by manufacturers or certification bodies. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of basic safety publications will not apply unless specifically referred to or included in the relevant publications. A group safety publication covers all safety aspects of a specific group of products within the scope of two or more product technical committees (TCs). Group safety publications are primarily intended to be stand-alone product safety publications but may also be used by TCs as source material in the preparation of their publications. A product safety publication covers all safety aspects of one or more products within the scope of a single product TC. The objectives of the development of this document are the following: to specifically reference and include relevant requirements, test methods or test conditions of relevant basic safety publications so that they become applicable; to specifically reference and inc
Scope: 1.1 General This part of IEC 62052 specifies general safety requirements and associated tests, with their appropriate conditions for type testing of directly connected, transformer-operated or transducer-operated AC and DC electricity meters and load control equipment. NOTE 1 For other general requirements, such as EMC, dependability, etc., see the relevant IEC 62052 or IEC 62059 standards. For accuracy requirements and other requirements specific to class indices, see the relevant IEC 62053 standards. This document applies to electricity metering equipment designed to: measure and control electrical energy on electrical networks (mains) with voltage up to 1 000 V AC or 1 500 V DC; NOTE 2 The voltage mentioned above is the line-to-neutral voltage AC RMS or DC derived from nominal voltages. See Table 7. have all functional elements, including add-on communication modules, enclosed in, or forming a single meter case with exception of indicating displays; operate with integrated displays (electromechanical or static meters); operate with detached indicating displays or without an indicating display (static meters only); wall-mounted or to be installed in specified matching sockets or racks; optionally provide additional functions other than those for measurement of electrical energy. NOTE 3 Modern electricity meters typically contain additional functions such as measurement of voltage magnitude, current magnitude, power, frequency, power factor, etc.; measurement of power quality parameters; load control functions; delivery, time, test, accounting, and recording functions; data communication interfaces and associated data security functions. The relevant standards for these functions may apply in addition to the requirements of this document. However, the requirements for such functions are outside the scope of this document. NOTE 4 Product requirements for Power Metering and Monitoring Devices (PMDs) and measurement functions such as voltage magnitude, current magnitude, power, frequency, etc., are covered in IEC 61557-12. However, devices compliant with IEC 61557-12 are not intended to be used as billing meters unless they are also compliant with the IEC 62052-11
Contents:
- FOREWORD
- INTRODUCTION
- Scope