IEC 62153-4-7-2025 PDF

IEC 62153-4-7-2025 PDF

Metallic cables and other passive components test methods - Part 4-7: Electromagnetic compatibility (EMC) -Test method for measuring of transfer impedance ZT and screening attenuation aS or coupling attenuation aC of connectors and assemblies - Triaxial tube in tube method

$447.66 $895.31 -50%
Product Code: IEC 62153-4-7
Stock In Stock
Edition: 3.1
Published: 11/2025
Number of Pages: 140
File Size: 1 file, 3 Bytes

Available Options

Product Description

Metallic cables and other passive components test methods - Part 4-7: Electromagnetic compatibility (EMC) -Test method for measuring of transfer impedance ZT and screening attenuation aS or coupling attenuation aC of connectors and assemblies - Triaxial tube in tube method

Introduction: The shielded screening attenuation test set-up according to IEC 62153-4-3 and IEC 62153‑4‑4 have been extended to take into account the particularities of electrically short elements like connectors and cable assemblies. Due to the concentric outer tube of the triaxial set-up, measurements are independent of irregularities on the circumference and outer electromagnetic fields. With the use of an additional resonator tube (inner tube respectively tube in tube), a system is created where the screening effectiveness of an electrically short device is measured in realistic and controlled conditions. Also, a lower cut off frequency for the transition between electrically short (transfer impedance ZT) and electrically long (screening attenuation aS) can be achieved. A wide dynamic and frequency range can be applied to test even super screened connectors and assemblies with normal instrumentation from low frequencies up to the limit of defined transversal waves in the outer circuit at approximately 4 GHz. INTRODUCTION to Amendment The goal of this amendment is: to extend coupling attenuation measurements to unscreened connectors and cable assemblies to extend coupling attenuation measurements of connectors and cable assemblies to low frequencies by introducing the LFCA to extend 10.5, expression of results by a conversion formula between scattering parameter and coupling attenuation to introduce the application of a 20 dB/dec envelope curve for coupling attenuation to introduce the

Scope: This part of IEC 62153 deals with the triaxial tube in tube method. This triaxial method is suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin connectors and multicore cable assemblies. For the measurement of transfer impedance and screening- or coupling attenuation, only one test set-up is needed.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62153-4-7-2025 PDF

IEC 62153-4-7-2025 PDF

$447.66 $895.31