Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility requirements for AC pin and contact-tube accessories
Introduction: The IEC 61851 series specifies requirements for electric vehicle (EV) conductive supply equipment. The IEC 62196 series specifiy the requirements for plugs, socket-outlets, vehicle connectors, vehicle inlets and cable assemblies as described in the IEC 61851 series and in IEC 62752. Some charging using on-board vehicle chargers can be achieved by direct connection from an electric vehicle to an AC supply network using common socket-outlets or by the use of equipment incorporating control and communication circuits. To support the connection of AC power for such vehicles, this document provides the standard interface configurations of AC vehicle couplers and accessories to be used in conductive charging of electric vehicles, taking the most frequent charging situations into consideration. The IEC 62196 series consists of the following parts: IEC 62196-1: General requirements, comprising clauses of a general character; IEC 62196-2: Dimensional compatibility requirements for AC pin and contact-tube accessories; IEC 62196-3: Dimensional compatibility requirements for DC and AC/DC pin and contact- tube vehicle couplers; IEC TS 62196-4: Dimensional compatibility and interchangeability requirements for DC pin and contact-tube accessories for class II or class III applications; IEC 62196-6: Dimensional compatibility requirements for DC pin and contact-tube vehicle couplers intended to be used for DC EV supply equipment where protection relies on electrical separation; IEC TS 62196-71
Scope: This part of IEC 62196 applies to EV plugs, EV socket-outlets, vehicle connectors and vehicle inlets with pins and contact-tubes of standardized configurations, herein referred to as "accessories". These accessories have a nominal rated operating voltage not exceeding 480 V AC, 50 Hz to 60 Hz, and a rated current not exceeding 63 A three phase or 70 A single phase, for use in conductive charging of electric vehicles. This document covers the basic interface accessories for vehicle supply as specified in IEC 62196-1:2025. NOTE 1 The term "electric road vehicles (EV)" comprises all road vehicles, including plug-in hybrid road vehicles (PHEV) that derive all or part of their energy from the rechargeable energy storage systems (RESS). These accessories are intended to be used for circuits specified in IEC 61851-1 and IEC 62752, which operate at different voltages and frequencies, and which can include extra-low voltage (ELV) and communication signals. The use of these accessories for bidirectional power transfer is under consideration. This document applies to accessories to be used in an ambient temperature between –30 °C and +40 °C. NOTE 2 In the following country, other requirements regarding the lower temperature can apply: NO. NOTE 3 In the following country, −40 °C applies: SE. These accessories are intended to be connected only to cables with copper or copper-alloy conductors. Vehicle inlets and vehicle connectors described in this document are intended to be used for charging in modes 1, 2 and 3, cases B and C. The EV socket-outlets and EV plugs covered by this document are intended to be used for charging mode 3 only, case A and B. The modes and permissible connections are specified in IEC 61851-1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 6.201 Communication and control pilot function
- 7.201 According to the standard sheet used
- 9.201 Standard sheets
- 13.201 Wire connections of components
- 14.201 Engage and disengage the latching device (configurations without a
- 14.201.1 General
- 14.201.2 Samples
- 14.201.3 Test sequence
- 14.201.4 Test gauges