Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility requirements for DC and AC/DC pin and contact-tube vehicle couplers
Introduction: The IEC 61851 series specifies requirements for electric vehicle (EV) conductive supply equipment. The IEC 62196 series specifies the requirements for plugs, socket-outlets, vehicle connectors, vehicle inlets and cable assemblies as described in the IEC 61851 series and in IEC 62752. Charging using off-board DC charging equipment can be achieved by the direct connection of an electric vehicle to DC EV supply equipment incorporating control and communication circuits. To support the connection of DC power for such vehicles, this document provides the standard interface configurations of DC vehicle couplers and accessories to be used in conductive charging of electric vehicles, taking the most frequent charging situations into consideration. The IEC 62196 series consists of the following parts: IEC 62196-1: General requirements, comprising clauses of a general character; IEC 62196-2: Dimensional compatibility requirements for AC pin and contact-tube accessories; IEC 62196-3: Dimensional compatibility requirements for DC and AC/DC pin and contact- tube vehicle couplers; IEC TS 62196-4: Dimensional compatibility and interchangeability requirements for DC pin and contact-tube accessories for class II or class III applications; IEC 62196-6: Dimensional compatibility requirements for DC pin and contact-tube vehicle couplers intended to be used for DC EV supply equipment where protection relies on electrical separation. IEC TS 62196-7: Vehicle adapter
Scope: This part of IEC 62196 is applicable to vehicle couplers with pins and contact tubes of standardized configuration, herein also referred to as "accessories", intended for use in electric vehicle conductive charging systems which incorporate control means, with rated operating voltage and current in accordance with IEC 62196-1:2025. This document applies to high power DC interfaces and combined AC/DC interfaces of vehicle couplers that are intended for use in conductive charging systems for circuits specified in IEC 61851-1 and IEC 61851-23. This document applies to accessories and cable assemblies that employ thermal sensing, or thermal transport and thermal sensing with the system architecture described in AA.4.301. The DC vehicle connectors and vehicle inlets covered by this document are used only in charging mode 4, case C, as shown in IEC 618511. These vehicle couplers are intended to be used for circuits specified in IEC 61851-23 which operate at different voltages, and which can include ELV and communication signals. This document applies to the vehicle couplers to be used in an ambient temperature between –30 °C and +40 °C. NOTE 1 In some countries, other requirements can apply. NOTE 2 In the following country, −40 °C applies: SE. These vehicle couplers are intended to be connected only to cables with copper or copper-alloy conductors. These accessories are intended to be connected to cables according to the IEC 62893 series for DC cables.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 14.301 Latching function
- 14.302 Engage and disengage the latching device (configuration FF)
- 14.302.1 General
- 14.302.2 Samples
- 14.302.3 Test sequence
- 14.302.4 Test gauge