IEC 62220-1-2-2007 PDF

IEC 62220-1-2-2007 PDF

Medical electrical equipment-Characteristics of digital X-ray imaging devices-Part 1-2: Determination of the detective quantum efficiency-Detectors used in mammography

$132.41 $264.81 -50%
Product Code: IEC 62220-1-2
Stock In Stock
Edition: 1.0
Published: 06/2007
Number of Pages: 62
File Size: 1 file, 566 Bytes

Available Options

Product Description

Medical electrical equipment – Characteristics of digital X-ray imaging devices – Part 1-2: Determination of the detective quantum efficiency – Detectors used in mammography

Introduction: DIGITAL X-RAY IMAGING DEVICES are increasingly used in medical diagnosis and will widely replace conventional (analogue) imaging devices such as screen-film systems or analogue X- RAY IMAGE INTENSIFIER television systems in the future. It is necessary, therefore, to define parameters that describe the specific imaging properties of these DIGITAL X-RAY IMAGING DEVICES and to standardize the measurement procedures employed. There is growing consensus in the scientific world that the DETECTIVE QUANTUM EFFICIENCY (DQE) is the most suitable parameter for describing the imaging performance of an X-ray imaging device. The DQE describes the ability of the imaging device to preserve the signal-to- NOISE ratio from the radiation field to the resulting digital image data. Since in X-ray imaging, the NOISE in the radiation field is intimately coupled to the AIR KERMA level, DQE values can also be considered to describe the dose efficiency of a given DIGITAL X-RAY IMAGING DEVICE. NOTE In spite of the fact that the DQE is widely used to describe the performance of imaging devices, the connection between this physical parameter and the decision performance of a human observer is not yet completely understood [1], [3].1) The DQE is already widely used by manufacturers to describe the performance of their DIGITAL X-RAY IMAGING DEVICES. The specification of the DQE is also required by regulatory agencies (such as the Food and Drug Administration (FDA)) for admission procedures. However, there

Scope: This part of IEC 62220 specifies the method for the determination of the DETECTIVE QUANTUM EFFICIENCY (DQE) of DIGITAL X-RAY IMAGING DEVICES as a function of AIR KERMA and of SPATIAL FREQUENCY for the working conditions in the range of the medical application as specified by the MANUFACTURER. The intended users of this part of IEC 62220 are manufacturers and well equipped test laboratories. This Part 1-2 is restricted to DIGITAL X-RAY IMAGING DEVICES that are used for mammographic imaging such as but not exclusively, CR systems, direct and indirect flat panel detector based systems, scanning systems (CCD based or photon-counting). This part of IEC 62220 is not applicable to DIGITAL X-RAY IMAGING DEVICES intended to be used in general radiography or in dental radiography; computed tomography; and devices for dynamic imaging (where series of images are acquired, as in fluoroscopic or cardiac imaging). NOTE The devices noted above are excluded because they contain many parameters (for instance, beam qualities, geometry, time dependence, etc.) which differ from those important for mammography. Some of these techniques are treated in separate standards (IEC 62220-1 and IEC 62220-1-3) as has been done for other topics, for instance for speed and contrast, in IEC and ISO standards.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62220-1-2-2007 PDF

IEC 62220-1-2-2007 PDF

$132.41 $264.81