Railway applications - Electromagnetic compatibility - Part 3-1: Rolling stock - Train and complete vehicle
Introduction: High powered electronic equipment, together with low power microcontrollers and other electronic devices, is being installed on trains in great numbers. Electromagnetic compatibility has therefore become a critical issue for the design of train-related apparatus as well as of the train as a whole. This Product Standard for rolling stock sets limits for electromagnetic emission and immunity in order to ensure a well functioning system within its intended environment. Immunity limits are not given for the complete vehicle. Part 3-2 of this series defines requirements for the apparatus installed in the rolling stock, since it is impractical to test the complete unit. An EMC plan should be established for includes equipment covered by this document.
Scope: This part of IEC 62236 specifies the emission and immunity requirements for all types of rolling stock. It covers traction stock, hauled stock and trainsets including urban vehicles for use in city streets. This document specifies the emission limits of the rolling stock to the outside world. The scope of this document ends at the interface of the rolling stock with its respective energy inputs and outputs. In the case of locomotives traction units, trainsets, trams, etc., this is the current collector (pantograph, shoe gear). In the case of hauled stock, this is the AC or DC auxiliary power connector. However, since the current collector is part of the traction stock, it is not entirely possible to exclude the effects of this interface with the power supply line. The slow moving test has been designed to minimize these effects. Basically, all apparatus to be integrated into a vehicle should meet the requirements of Part 3- 2 of this standard. In exceptional cases, where apparatus meets another EMC standard, but full compliance with Part 3-2 is not demonstrated, EMC should be assured by adequate integration measures of the apparatus into the vehicle system and/or by an appropriate EMC analysis and test which justifies deviating from Part 3-2. There may be additional compatibility requirements within the railway system identified in the EMC plan (e.g. as specified in IEC 62427). The electromagnetic interference concerning Electromagnetic emissions of the railway system as a whole is are dealt with in IEC 62236-2. These specific provisions are to be used in conjunction with the general provisions in IEC 62236-1. The frequency range considered is from 0 Hz (DC) to 400 GHz. No measurements need to be performed at frequencies where no requirement is specified.
Contents:
- FOREWORD
- INTRODUCTION
- Scope