IEC 62246-1-2015 PDF

IEC 62246-1-2015 PDF

Reed switches-Part 1: Generic specification

$239.59 $479.18 -50%
Product Code: IEC 62246-1
Stock In Stock
Edition: 3.0
Published: 01/2015
Number of Pages: 168
File Size: 1 file, 1 Byte

Available Options

Product Description

Reed switches – Part 1: Generic specification

Introduction: Reed switches which are in mass production and which are widely used in practice could be classified by the following characteristics: a) Size: normal or standard reed switches with a tube more than 50 mm in length and more than 5 mm in diameter; sub-miniature reed switches with a tube > 25 mm and < 50 mm in length and < 5 mm in diameter; miniature reed switches with a tube > 10 mm and < 25 mm in length and > 2 mm and < 5 mm in diameter; micro-miniature reed switches with a tube > 4 mm and < 10 mm in length and > 1,5 mm and < 2 mm in diameter. b) Type of switching of electric circuit: closing or normally open – A type; opening or normally closed – B type; changeover – C type. c) Withstand voltage level: low-voltage (up to 1 000 V); high-voltage (more than 1 000 V). d) Switches power: low-power (up to 60 VA); power (100 to 1 000 VA); high-power (more than 1 000 VA). e) Types of electric contacts: the tube is filled with dry air, gas mixture, vacuumized, or high pressurized. This standard selects and specifies test procedures for reed switches where enhanced requirements for the verification of generic specification apply. An international standard IEC 62246-1-1 (a quality assessment specification including information of detail specification (DS)) was published in 2013.

Scope: This part of IEC 62246 which is a generic specification applies to all types of reed switches including magnetically biased reed switches of assessed quality for use in general and industrial applications. NOTE 1 Mercury wetted reed switches are not covered by this standard due to their possible environmental impact. It lists the tests and measurement procedures which may be selected for use in detail specifications for such reed switches. This standard applies to reed switches which are operated by an applied magnetic field; it is not restricted to any particular type of contact load. For elementary relays with reed switches, this standard is recommended to be used together with the standards IEC 61810-1, IEC 61811-1 as applicable. For applications of reed switches, this standard is recommended to be used together with specific product standards. NOTE 2 Where any discrepancies occur for any reasons, documents rank in the following order of authority: a) the detail specification, b) the sectional specification, c) the generic specification, d) any other international documents (for example, of the IEC) to which reference is made. The same order of precedence applies to equivalent national documents.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62246-1-2015 PDF

IEC 62246-1-2015 PDF

$239.59 $479.18