Railway applications – Automated urban guided transport (AUGT) – Safety requirements
Introduction: This International Standard is a generic guideline providing recommendations to assist railway authorities and safety regulatory authorities to define safety requirements appropriate to AUGT systems. The generic requirements recommended in this standard are based on the experience gained from AUGT systems already in operation. Safety requirements for each specific application, however, can only be defined from the results of a risk analysis, taking into consideration the conditions in which the AUGT system is to be set up and based on the risk acceptance principles prevailing in the local environment. The standard applicable for conducting a mandatory and comprehensive risk analysis of an AUGT system is IEC 62278 (RAMS). In view of the diversity of the technical solutions that may be adopted for new AUGT systems and the diversity of operational conditions, the list of generic hazardous situations considered in this standard should be regarded as a minimum list. The requirements for a safeguard as described in this standard are intended as minimum requirements in case a specific safeguard is applied to mitigate the related hazardous situation. However, the specific risk analysis may show that some requirements of a chosen safeguard should be modified to take into account some specific conditions. Each specific design of the new AUGT system and each aspect of the specific topographic, environmental, social or legal environment of the new AUGT system can also generate new hazard
Scope: This International Standard covers high-level safety requirements applicable to automated urban guided transport systems, with driverless or unattended self-propelled trains, operating on an exclusive guideway. This standard only deals with the safety requirements needed to compensate for the absence of a driver or attendant staff who would otherwise be responsible for some or all of train operation functions (see Table 1), depending on the level of automation of the system (see shaded areas in Table 1 and see 3.1 for a definition of the different grades of automation). The requirements of this standard are restricted to transports systems as defined in Clause 5 and to DTO and UTO as defined in 3.1.4 and 3.1.20, respectively (see the shaded areas in Table 1). 62267 © IEC:2009 – 9 – Table 1 – Grades of automation On-sight train operation Non- automated train operation Semi- automated train operation Driverless train operation Unattended train operation TOS NTO STO DTO UTO Basic functions of train operation GOA0 GOA1 GOA2 GOA3 GOA4 Ensure safe route (points command/ control in system) Ensure safe separation of trains Ensuring safe movement of trains Ensure safe speed (partly supervised by system) Driving Control acceleration and braking Prevent collision with obstacles Supervising guideway Prevent collision with persons Control passengers doors X or S Prevent injuries to persons between cars or between platform and train X or S Supervising passenger transfer Ensure safe starting conditions X or S Put in or take out of operation Operating a train Supervise the status of the train Ensuring detection and management of emergency situations Perform train diagnostic, detect fire/smoke and detect derailment, handle emergency situations (call/evacuation, supervision) S and/or staff in OCC NOTE X = responsibility of operations staff (may be realised by technical system). S = realised by technical system. This standard does not specifically look at security issues. However, aspects of safety requirements may apply to assuring security within the transport system. NOTE The definitions of “security” and “safety” are given by IEC 62278. Application of this standard is subsidia
Contents:
- FOREWORD
- INTRODUCTION
- Scope