High-voltage switchgear and controlgear – Part 212: Compact Equipment Assembly for Distribution Substation (CEADS) for AC voltages up to 52 kV
Introduction: Traditionally a high-voltage/low-voltage distribution substation has been constructed by installing the main electrical components –high-voltage switchgear and controlgear, power transformer and the corresponding low-voltage switchgear and controlgear- within a closed electrical operating area. It can be a room within a building intended for other usages (non electrical uses) or a separated housing (prefabricated or not) designed specifically to contain the electrical equipment of the substation or an open area limited by fences. Some years ago in the search for a more standardized and compact substation, the concept of prefabricated substation was developed. IEC 62271-202 covers this type of substation. According to this document, the main electrical components (high-voltage switchgear and controlgear, power transformer and low-voltage switchgear and controlgear) are fully in compliance with their respective product standard, and the whole substation, including interconnections and enclosure is designed and type tested and later manufactured and routine tested in the factory. Correspondingly the quality of the substation is assured by the manufacturer. Moreover, also other types of assemblies have been introduced in the market. These are assemblies comprising the main electrical active components of the substation and their interconnections, delivered as a single product. The product can therefore be type tested, manufactured, routine tested in the factory, transported and t
Scope: This part of IEC 62271 specifies the service conditions, rated characteristics, general structural requirements and test methods of the assemblies of the main electrical functional units of a high-voltage transformer substation, duly interconnected, for AC voltages up to and including 52 kV on the high-voltage side and service frequency 50 Hz or 60 Hz. The CEADS is cable-connected to the high-voltage network for indoor and outdoor applications of restricted access. A CEADS as defined in this document is designed and tested to be a single product with a single serial number and one set of documentation. The functions of a CEADS are: high-voltage/high-voltage or high-voltage/low-voltage transformation; and some or all the following: switching and control for the operation of the high-voltage circuit(s); switching and control for the operation of the low-voltage circuit(s); protection of the power transformer functional unit. The main functions are integrated in the following functional units: high-voltage functional unit; power transformer functional unit; low-voltage functional unit. NOTE For the purpose of this document a self-protected transformer is not considered as a CEADS, but as a functional unit, designed and type tested to its own product standard IEC 60076-13:2006.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 5.101 Rated power and total losses of CEADS
- 5.102 Ratings of the internal arc classification (IAC)