IEC 62282-3-100-2019 PDF

IEC 62282-3-100-2019 PDF

Fuel cell technologies-Part 3-100: Stationary fuel cell power systems-Safety

$239.59 $479.18 -50%
Product Code: IEC 62282-3-100
Stock In Stock
Edition: 2.0
Published: 02/2019
Number of Pages: 170
File Size: 1 file, 1 Byte

Available Options

Product Description

Fuel cell technologies – Part 3-100: Stationary fuel cell power systems – Safety

Introduction: A typical stationary fuel cell power system is shown in Figure 1. Figure 1 – Typical stationary fuel cell power system The overall design of the power system anticipated by this document forms an assembly of integrated systems, as necessary, intended to perform designated functions, as follows. Fuel processing system – System of chemical and/or physical processing equipment plus associated heat exchangers and controls required to prepare, and if necessary, pressurize, the fuel for utilization within a fuel cell power system. Oxidant processing system – System that meters, conditions, processes and may pressurize the incoming supply for use within the fuel cell power system. Thermal management system – System that provides heating or cooling and heat rejection to maintain the fuel cell power system in the operating temperature range, and may provide for the recovery of excess heat and assist in heating the power train during start- up. Water treatment system – System that provides all the necessary purification treatment of the recovered or added water for use within the fuel cell power system. Power conditioning system – Equipment that is used to adapt the electrical energy produced by the fuel cell stack(s) to application requirements as specified by the manufacturer. Automatic control system – System(s) that is composed of sensors, actuators, valves, switches and logic components that maintain the fuel cell power system parameters within the manufacturer’s specified limits

Scope: This part of IEC 62282 applies to stationary packaged, self-contained fuel cell power systems or fuel cell power systems comprised of factory matched packages of integrated systems which generate electricity through electrochemical reactions. This document applies to systems intended for electrical connection to mains direct, or with a transfer switch, or to a stand- alone power distribution system; intended to provide AC or DC power; with or without the ability to recover useful heat; intended for operation on the following input fuels: natural gas and other methane rich gases derived from renewable (biomass) or fossil fuel sources, for example, landfill gas, digester gas, coal mine gas; fuels derived from oil refining, for example, diesel, gasoline, kerosene, liquefied petroleum gases such as propane and butane; alcohols, esters, ethers, aldehydes, ketones, Fischer-Tropsch liquids and other suitable hydrogen-rich organic compounds derived from renewable (biomass) or fossil fuel sources, for example, methanol, ethanol, di-methyl ether, biodiesel; hydrogen, gaseous mixtures containing hydrogen gas, for example, synthesis gas, town gas. This document does not cover: micro fuel cell power systems; portable fuel cell power systems; propulsion fuel cell power systems. NOTE For special applications such as “marine auxiliary power”, additional requirements can be given by the relevant marine ship register standard. This document is applicable to stationary fuel cell power systems intended for indoor and outdoor commercial, industrial and residential use in non-hazardous areas. This document contemplates all significant hazards, hazardous situations and events, with the exception of those associated with environmental compatibility (installation conditions), relevant to fuel cell power systems, when they are used as intended and under the conditions foreseen by the manufacturer. This document deals with conditions that can yield hazards on the one hand to persons, and on the other to damage outside the fuel cell power system only. Protection against damage to the fuel cell power system internals is not addressed in this document, provided it does not lead to hazards ou

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62282-3-100-2019 PDF

IEC 62282-3-100-2019 PDF

$239.59 $479.18