Fuel cell technologies – Part 5-100: Portable fuel cell power systems – Safety
Scope: This part of IEC 62282 covers construction, marking and test requirements for portable fuel cell power systems. These fuel cell systems are movable and not fastened or otherwise secured to a specific location. The purpose of the portable fuel cell power system is to produce electrical power. This document applies to AC and DC type portable fuel cell power systems, with a rated output voltage not exceeding 600 V AC, or 850 V DC for indoor and outdoor use. These portable fuel cell power systems cannot be used in hazardous locations as defined in IEC 60050-426:2008, 426-03-01 unless there are additional protective measures in accordance with IEC 60079-0[5]1). This document does not apply to portable fuel cell power systems that are permanently connected (hard wired) to the electrical distribution system, 1) permanently connected to a utility fuel distribution system, 2) exporting power to the grid, 3) for propulsion of road vehicles, 4) intended to be used on board passenger aircraft. 5) Fuel cells that provide battery charging for hybrid vehicles where the battery provides power and energy for propulsion of the vehicle are not included in the scope of this document The following fuels and fuel feedstocks are considered within the scope of this document: natural gas, liquefied petroleum gas, such as propane and butane, liquid alcohols, for example methanol, ethanol, gasoline, diesel, kerosene, hydrogen, chemical hydrides. This document does not preclude the use of similar fuels or oxidants from sources other than air provided the unique hazards are addressed through additional requirements. ___________ 1) Numbers in square brackets refer to the Bibliography. IEC 62282-5-100:2018 © IEC 2018 – 9 – Key EMD electromagnetic disturbance EMI electromagnetic interference Figure 1 – Portable fuel cell power systems The overall design of a portable fuel cell power system anticipated by this document forms an assembly of some or all of the following systems (see Figure 1), integrated as necessary, to perform designated functions, as follows: Fuel processing system – chemical processing equipment including any associated heat exchangers and controls required to convert input f
Contents: