Determination of certain substances in electrotechnical products – Part 3-3: Screening – Polybrominated biphenyls, polybrominated diphenyl ethers and phthalates in polymers by gas chromatography-mass spectrometry using a pyrolyser/thermal desorption accessory (Py/TD-GC-MS)
Introduction: The widespread use of electrotechnical products has drawn increased attention to their impact on the environment. In many countries all over the world, this has resulted in the adaptation of regulations affecting wastes, substances and energy use of electrotechnical products. The use of polybrominated biphenyls (PBBs), polybrominated diphenyl ethers (PBDEs) and certain phthalates in electrotechnical products is of concern in many regions of the world. The purpose of this document is therefore to provide a test method that will allow the electrotechnical industry to determine the levels of polybrominated biphenyls (PBBs), polybrominated diphenyl ethers (PBDEs), di-isobutyl phthalate (DIBP), di-n-butyl phthalate (DBP), benzylbutyl phthalate (BBP), di-(2-ethylhexyl) phthalate (DEHP), di-n-octyl phthalate (DNOP), di-isononyl phthalate (DINP) and di-isodecyl phthalate (DIDP) in electrotechnical products on a consistent global basis. WARNING – Persons using this document should be familiar with normal laboratory practice. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any national regulatory conditions.
Scope: This part of IEC 62321 specifies the screening analysis of polybrominated biphenyls (PBBs), polybrominated diphenyl ethers (PBDEs), di-isobutyl phthalate (DIBP), di-n-butyl phthalate (DBP), benzylbutyl phthalate (BBP), di-(2-ethylhexyl) phthalate (DEHP), di-n-octyl phthalate (DNOP), di-isononyl phthalate (DINP), and di-isodecyl phthalate (DIDP) in polymers of electrotechnical products using the analytical technique of gas chromatography-mass spectrometry using a pyrolyser/thermal desorption accessory (Py/TD-GC-MS). This test method has been evaluated through the analysis of PP (polypropylene), PS (polystyrene), and PVC (polyvinyl chloride) materials containing deca-BDE between 100 mg/kg and 1 000 mg/kg and individual phthalates between 100 mg/kg to 4 000 mg/kg as depicted in Annex J. Use of the methods described in this document for other polymer types, PBBs (mono-deca), PBDEs (mono-deca) and phthalates or concentration ranges other than those specified above has not been specifically evaluated. This document has the status of a horizontal standard in accordance with IEC Guide 108 [1]1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope