IEC 62365-2009 PDF

IEC 62365-2009 PDF

Digital audio-Digital input-output interfacing-Transmission of digital audio over asynchronous transfer mode (ATM) networks

$132.41 $264.81 -50%
Product Code: IEC 62365
Stock In Stock
Edition: 2.0
Published: 05/2009
Number of Pages: 64
File Size: 1 file, 471 Bytes

Available Options

Product Description

Digital audio – Digital input-output interfacing – Transmission of digital audio over asynchronous transfer mode (ATM) networks

Introduction: This International Standard describes means for the transmission of professional audio across digital networks, including metropolitan- and wide-area networks, to provide the best performance with regard to latency, jitter, and other relevant factors. Current-generation wide-area communications are based on two very similar systems, synchronous optical network (SONET) and synchronous digital hierarchy (SDH), SONET being used in the United States and SDH in Europe. On top of them are run integrated services digital network (ISDN), asynchronous transfer mode (ATM), and Internet protocol (IP). ISDN provides telephone call connections of a fixed capacity that carry one 8-bit value per 125 µs; when a call is set up, its route through the system is chosen, and the switches that route the data are configured accordingly. Each link, between switches or between switch and end equipment, is formatted into frames that take 125 µs to transmit, and each data byte is identified by its position in the frame. ATM, also called broadband ISDN, provides a service similar to ISDN, but with the capacity of each call being specified by the caller. Links are formatted into cells, which consist of a header and 48 data bytes; the header is typically 5 bytes long, and most of it is taken up with the virtual channel identifier (VCI) that shows to which call the cell belongs. Call set-up, routeing, and switching are done in the same way as in ISDN, but with calls not being restricted to 1 byte every 125

Scope: This International Standard specifies a means to carry multiple channels of audio in linear PCM or IEC 60958-4 format over an ATM layer service conforming to ITU-T Recommendation I.150. It includes a means to convey, between parties, information concerning the digital audio signal when setting up audio calls across the ATM network. It does not specify the physical interface to the network.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62365-2009 PDF

IEC 62365-2009 PDF

$132.41 $264.81