Electrical resistance trace heating systems for industrial and commercial applications – Part 1: General and testing requirements
Introduction: IEC 62395-1 provides the essential requirements and testing appropriate to electrical resistance trace heating equipment used in industrial and commercial applications. While some of this work already exists in national or international standards, this standard has collated much of this existing work and added considerably to it. IEC 62395-2 provides detailed recommendations for the system design, installation and maintenance of electric trace heating systems in industrial and commercial applications. It is the objective of IEC 62395 that, when in normal use, electrical trace heating systems operate safely under their defined conditions of use, by a) employing heaters of the appropriate construction and meeting the test criteria detailed in IEC 62395-1. The construction includes a metallic sheath, braid, screen or equivalent electrically conductive covering; b) operating at safe temperatures when designed, installed, and maintained in accordance with IEC 62395-2. c) having at least the minimum levels of overcurrent and earth-fault protection required in IEC 62395-1 and IEC 62395-2.
Scope: This part of IEC 62395 specifies requirements for electrical resistance trace heating systems and includes general test requirements. This standard pertains to trace heating systems that may comprise either factory-fabricated or field-assembled (work-site) units, and which may be series and parallel trace heaters or surface heaters (heater pads and heater panels) that have been assembled and/or terminated in accordance with the manufacturer’s instructions. This standard also includes requirements for termination assemblies and control methods used with trace heating systems. This standard provides the essential requirements and testing appropriate to electrical resistance trace heating equipment used in industrial and commercial applications. The products certified according to this standard are intended to be installed by persons who are suitably trained in the techniques required and that only trained personnel carry out especially critical work, such as the installation of connections and terminations. Installations are intended to be carried out under the supervision of a qualified person who has undergone supplementary training in electric trace heating systems. This standard does not include or provide for any applications in potentially explosive atmospheres. This standard does not cover induction, impedance or skin effect heating. Trace heating systems can be grouped into different types of applications and the different conditions found during and after installation necessitate different requirements for testing. Trace heating systems are usually certified for a specific type of installation or application. Typical applications for the different types of installation include, but are not limited to: a) installations of trace heating for surface heating on pipes, vessels and associated equipment – applications include: freeze protection and temperature maintenance; hot water lines; oil and chemical lines; sprinkler system mains and supply piping; b) outdoor exposed area installations of trace heating – applications include: roof de-icing; gutter and down-spout de-icing; catch basins and drains; rail heating2; ————————— Further evaluation may be required
Contents:
- FOREWORD
- INTRODUCTION
- Scope