Sound system equipment – Electroacoustical transducers – Measurement of suspension parts
Introduction: The properties of the suspension parts such as spiders and surrounds have a significant influence on the final sound quality of the loudspeaker. This International Standard defines measurement methods and parameters required for development and quality-assurance by suspension-part manufacturers and loudspeaker manufacturers. Static and dynamic methods have been developed for measuring the suspension parts at small and high amplitudes. Due to the visco-elastic properties of the suspension material (fabric, rubber, foam, paper) the measurement results depend on the measurement conditions and are not comparable between different methods. For example, the properties measured by static method significantly deviate from the dynamic behaviour of the suspension material when excited by an audio signal. This standard defines the terminology, the characteristics which should be specified and the way the results should be reported. The goal is to improve the reproducibility of the measurement, to simplify the interpretation of the results and to support the communication between manufacturers of suspension parts and complete drive units.
Scope: This International Standard applies to the suspension parts of electroacoustic transducers (for example, loudspeakers). It defines the parameters and measurement method to determine the properties of suspension parts like spiders, surrounds, diaphragms or cones before being assembled in the transducer. The measurement results are needed for engineering design purposes and for quality control. Furthermore, this method is intended to improve the correlation of measurements between suspension-part manufacturers and loudspeaker manufacturers. The measurement methods provide parameters based on linear and nonlinear modelling of the suspension part and uses both static and dynamic techniques.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Dynamic stiffness K(xac)
- 10.1 Characteristic to be specified
- 10.2 Method of measurement
- 10.2.1 General
- 10.2.2 Test equipment
- 10.2.3 Procedure
- 10.2.4 Presentation of results
- 11 Coefficients of the power series expansion of K(x)
- 11.1 Characteristics to be specified