Photobiological safety of lamps and lamp systems – Part 6: Ultraviolet lamp products
Introduction: Most lamps and lamp products are safe and do not pose photobiological risks except under unusual exposure conditions; however, one group of products-ultraviolet lamp products-can under some conditions pose optical hazards during use and require risk assessment for direct and indirect exposure of the eyes and skin. Optical radiation hazards from all types of lamps or other broadband light sources are assessed by the application of IEC 62471:2006/CIE S009:2002. IEC 62471 covers light emitting diodes (LEDs), incandescent, low- and high- pressure gas-discharge, arc and other lamps. It also covers lamps which are designed primarily to emit ultraviolet radiant energy, such as ultraviolet sources intended to excite fluorescence of irradiated materials, for insect light traps, for scientific studies, mineral identification, for non-destructive testing, germicidal irradiation, and other purposes. This document provides a risk group (RG) classification system for all ultraviolet lamp products, and the assessment distances and measurement conditions for different products (Annex A and Annex C). It includes manufacturing and user safety requirements that may be required as a result of an ultraviolet lamp product being assigned to a particular risk group. The scope is limited to products where the sole intent is to emit ultraviolet radiant energy. The advantage of applying this document, intended solely for ultraviolet lamp products, instead of the horizontal IEC 62471 standard, is that t
Scope: This part of IEC 62471 provides the optical radiation safety requirements for ultraviolet lamp products, including UV LED lamp products. This document provides requirements for: optical radiation safety assessment and ultraviolet-product risk groups; user information for safety measures; appropriate labelling of ultraviolet lamp products. This document addresses those lamps and lamp products where the ultraviolet emission serves the primary purpose of the product and where more than half of the radiant power emitted between 180 nm and 3 000 nm is in the spectral region 180 nm to 400 nm. If more than half of the optical radiation emitted between 180 nm and 3 000 nm is outside of the spectral region 180 nm to 400 nm, then the base standard IEC 62471 should be used. This document covers medical diagnostic and cosmetic devices/products that emit primarily UV radiation. Because photobiological effects from UV radiation are based on the total accumulated exposure (dose) received, this document relies on the concept of ‘time-weighted average’ exposures where the assessment distance for determining the RG is chosen based on realistic exposure distances and exposure durations. In other words, it is not expected that people will be exposed at very close distances, e.g. 20 cm to 30 cm, for extended periods of time. This document provides assessment distances and specific guidance that are application-specific and realistic rather than the more general values in IEC 62471 where the specific application is unknown and time-weighted average exposures are not application-specific. This document does not provide requirements for: lamps which primarily emit visible (such as GLS – general lighting source) and/or infrared radiant energy; lamp products used for general lighting or infrared illumination or heating, which are treated in separate standards; fluorescent ultraviolet lamps for tanning (covered by IEC 60335-2-27 and IEC 61228); medical treatment devices/products (see IEC 60601-2-57), but covers UV medical diagnostic products; non-optical hazards, e.g. ozone, mercury, etc.
Contents:
- FOREWORD
- INTRODUCTION
- Scope