Safety requirements for power electronic converter systems and equipment – Part 1: General
Introduction: This document relates to products that include power electronic converters, with a rated system voltage not exceeding 1 000 V AC or 1 500 V DC. It specifies requirements to reduce risks of fire, electric shock, thermal, energy and mechanical hazards, except functional safety as defined in IEC 61508 (all parts). The objectives of this document are to establish a common terminology and basis for the safety requirements of products that contain power electronic converters across several IEC technical committees. During the update of the document, feedback from technical committees which used the IEC 62477‑1 as reference document has been taken into consideration. Modifications have been made to 4.4.2 and Annex A considering the safe to touch voltage DVC As under normal operating conditions and single fault conditions. On request from TCs using this document as a reference document, the determination of DVC As has been simplified. The determination of DVC As in IEC 62477-1:2012 and IEC 62477-1:2012/AMD1:2016 was developed based on IEC TS 60479-1:20051 and IEC TR 60479-5:2007 and in details taking different environmental condition, size of body contact area and body reaction into consideration. This change also included time-voltage zones in Annex A for relevant body reactions, environmental conditions and contact area. NOTE See IEC 60479-1:2018 for further information about effects of current on human beings and livestock. This document follows the simplified concepts of the basi
Scope: This part of IEC 62477 applies to power electronic converter systems (PECS), any specified accessories, and their components for electronic power conversion and electronic power switching, including the means for their control, protection, monitoring and measurement, such as with the main purpose of converting electric power, with rated system voltages not exceeding 1 000 V AC or 1 500 V DC. This document also applies to PECS which intentionally emit or receive radio waves for the purpose of radio communication. This document can also be used as a reference standard for product committees producing product standards for: adjustable speed electric power drive systems (PDS); standalone uninterruptible power systems (UPS); low voltage stabilized DC power supplies; bidirectional power converters. For PECS and their specified accessories for which no product standard exists, this document provides minimum requirements for safety aspects. This document has the status of a group safety publication in accordance with IEC Guide 104 for power electronic converter systems for solar, wind, tidal, wave, fuel cell or similar energy sources. According to IEC Guide 104, one of the responsibilities of technical committees is, wherever applicable, to make use of basic safety publications and/or group safety publications in the preparation of their product standards. Guidance for use of this group safety publication for product committees is given in Annex S. This document establishes a common terminology for safety aspects relating to PECS, establishes minimum requirements for the coordination of safety aspects of interrelated parts within a PECS, establishes a common basis for minimum safety requirements for the PECS portion of products that contain PECS, specifies requirements to reduce risks of fire, electric shock, thermal, energy and mechanical hazards, during use and operation and, where specifically stated, during service and maintenance, and specifies minimum requirements to reduce risks with respect to PECS designed as pluggable and permanently connected equipment, whether it consists of a system of interconnected units or independent units, subject to installing, operat
Contents:
- FOREWORD
- INTRODUCTION
- Scope