IEC 62520-2011 PDF

IEC 62520-2011 PDF

Railway applications-Electric traction-Short-primary type linear induction motors (LIM) fed by power converters

$163.93 $327.86 -50%
Product Code: IEC 62520
Stock In Stock
Edition: 1.0
Published: 05/2011
Number of Pages: 66
File Size: 1 file, 1 Byte

Available Options

Product Description

Railway applications – Electric traction – Short-primary type linear induction motors (LIM) fed by power converters

Introduction: This International Standard is introduced because there are significant differences between the rotary induction motor and the linear induction motor (LIM). These differences necessitate a different testing standard to ensure consistency, repeatability and dependability of the test results. For clarification, the significant differences are listed below: a) The LIM has a power factor and an electric efficiency substantially lower than those of rotary motors, because its magnetic gap length is several times that of the rotary motors. As such, the assumption made for the rotary induction motor that the primary leakage reactance is significantly less than the mutual reactance is no longer valid. b) The traction efficiency of a LIM does not include the mechanical transmission, typical of rotary motor propulsion. c) LIMs produce direct thrust between the primary and secondary without the need for mechanical contact. Therefore, there are no adhesion limits due to the rail and wheels contact of the typical rotary drive. No spin/slide controls are needed with LIMs and thus there is no need for testing of this function. d) LIMs produce not only thrust (which is in the longitudinal direction) but also normal and lateral forces which are effectively eliminated in the rotary induction motor, due to the symmetrical geometry of rotary motor. The normal force is either an attraction or a repulsion between the primary and secondary. The effect of these forces should be considered on deflecti

Scope: This International standard applies to short-primary type linear induction motors (LIM) for propelling rail and road vehicles. This standard applies to a specific configuration of LIM that has the primary mounted on either the vehicle body or trucks and a secondary that is fixed to the track and that is connected only by a magnetic field with the primary. The object of this standard is to allow the performance of a LIM to be confirmed by tests and to provide a basis for assessment of its suitability for a specified duty. The rating of LIMs fed in parallel by a common converter should take into account the effect on load-sharing due to differences of gap length and of LIM characteristics. The user should be informed of the maximum permissible difference in gap length for the particular application. The electrical input to LIMs covered by this standard should come from an electronic converter. NOTE At the time of drafting, only the following combination of LIMs and converters had been used for traction applications, but it may also apply to other combinations which may be used in the future: LIMs fed by voltage source converters.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62520-2011 PDF

IEC 62520-2011 PDF

$163.93 $327.86